User manual ARTHUR MARTIN AFT602W

[. . . ] SAFETY RECOMMENDATIONS - This oven was designed for use by private persons in their homes. Make sure that children do not touch and that they do not treat it as a toy. Make note of any concerns or reservations on the delivery slip and make sure to keep a copy of this form. Do not use it for commercial or industrial purposes or for any other purpose than that for which it was designed. [. . . ] - The appliance must be unplugged during installation or when any repairs or maintenance work is being performed. - Ensure that the network voltage corresponds to the voltage noted on the identification plate located inside the hood. - If the electrical installation at your residence requires any changes in order to hook up your Appliance, call upon a professional electrician. - If the hood is being used in evacuation mode, do not connect the appliance to a combustion gas exhaust duct (boiler, chimney, etc. - Under no circumstances should the exhaust duct empty into the attic. - Install the hood at safe distance of at least 65 cm from an cooking hob. This appliance can be installed in either duction version or filtering version. 1) Your hood can be connected to this outlet using a flue (Ø 150mm that is enamelled, in aluminium, flexible or made of inflammable material). USING THE FILTERING MODE If you do not posses an oulet to the exterior (fig. The air and steam taken up by the unit are purified with charcoal filter and returned to the environment through the aeration grids on the side of the telescopic flue. ELECTRICAL CONNECTIONS During installation and maintenance operations, the appliance must be unplugged from the electrical grid; fuses must be cut off or removed. Ducting mode - Using the supplied screws and screw anchors, fix the upper flue bearing bracket to the ceiling and/ or wall, checking that it is aligned with the hood (Fig. - Connect the air outlet pipe to the air vent of the hood; use a flexible pipe and lock it to the air vent of the hood with a metal hose clamp - Fig. - For ducting hoods, turn the upper flue over so that the air exhaust grid is in the lower section (Fig. Warning This is the filtering version of your cooker hood; you must first remove the charcoal filter. For optimal use of your appliance, we recommend that you connect the hood to a 150 mm-diameter flue (not delivered with the appliance). In the event that the hood will be operated using out-door evacuation, you should ensure a sufficient inflow of fresh air to avoid a pressure deficiency in the room. In the case of installation with air evacuation to the outside, fitting the non-return valve prevents the wind from entering and the air from returning. - Using the supplied screws and screw anchors, fix the upper flue bearing bracket to the ceiling and/ or wall, checking that it is aligned with the hood (Fig. 10T) locking it with a metal hose clamp (pipe and clamps are not provided). - Draw the set of the flues near the upper part of the hood and fix the pipe to the flange. Minor differences in details and fittings may emerge between your appliance and the descriptions provided. [. . . ] Before carrying out any work, the power supply to the hood must be turned off, either by unplugging it or by using the circuit breaker switch. PRODUCTS/ACCESSORIES TO USE To clean the body and the lighting port, you should use only commercial household cleaning products diluted in water and then rinse using clean water, drying with a soft cloth. Use a commercial household cleaning product then rinse abundantly and dry. These filters can be cleaned in a vertical position in your dishwasher. [. . . ]