User manual ARTHUR MARTIN AFT629B

[. . . ] 8 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Attaching flue duct. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 INSTRUCTION MANUAL Additional information on products, accessories, replacement parts and services can be found at www. bosch-home. com and in the online shop www. bosch-eshop. com Produktinfo Environmental protection This appliance is labelled in accordance with the European Directive 2002/96/EU concerning used electrical and electronic appliances (WEEE ­ waste electrical and electronic equipment). The guideline determines the framework for the return and recycling of used appliances as applicable. Please find the contact data of all countries in the enclosed customer service list. [. . . ] Unrestricted operation is possible if the vapour extractor hood is operated exclusively in the recirculation mode. Risk of damage from heat accumulation due to too narrow gap between appliance and high-sided unit or wall. Only one side of the appliance may be installed directly next to a high-sided unit or a wall. Distance between the appliance and wall or highsided unit must be at least 50 mm. If gas and electric hobs are operated together, the largest specified distance applies. The width of the extractor hood must correspond at least with the width of the hob. For the installation observe the currently valid building regulations and the regulations of the local electricity and gas suppliers. A damaged connection cable must be replaced by a qualified technician (electrician). All safety screws and safety caps must be firmly fitted. Caution!Do not look directly into the switched on LED lights for longer than 100 seconds. Cleaning and care Risk of burns, risk of electric shock!Caution! Risk of damage due to ingress of humidity into the electronic circuitry. Clean the metal-mesh grease filters under normal use (1 to 2 hours daily) approx. Notes Do not use any aggressive, acidic or alkaline cleaning agents. Risk of damage due to ingress of humidity into the electronic circuitry. Never use strong and abrasive cleaning agents. When cleaning the metal-mesh grease filters, also clean the holder for the metal-mesh grease filters in the appliance using a damp cloth. The metal-mesh grease filters can be cleaned in the dishwasher or by hand. Cleaning appliance surface Suitable cleaning agents and care products for your appliance can be purchased via the Hotline or from the Online Shop (see front of the instructions for use). Do not look directly into the switched on LED lights for longer than 100 seconds. 3. Insert mains plug or switch on fuse again. 6 INSTALLATION INSTRUCTIONS Ins tallation in structio ns HOHFWUR JD] [ [ !Follow the enclosed installation instructions for additional special accessories (e. g. Avoid damaging them during installation. Safety notes ã=Mortal danger, risk of intoxication! Due to combustion gases sucked back in. Never operate the appliance in the exhaust air mode at the same time as a room air-dependent heat-producing appliance unless an adequate supply of fresh air is ensured. He is able to assess the house's entire ventilation setup and will suggest the suitable ventilation measures to you. Unrestricted operation is possible if the vapour extractor hood is operated exclusively in the recirculation mode. ã=Risk of fire! from flying sparks. [. . . ] Exhaust-air pipe Ø 150 mm (recommended size) Attach exhaust-air pipe directly to the air-pipe connector and seal. Push one flue duct into the other. Notes To prevent scratches, place paper for protection over the edges of the outer flue duct. ­ Slots of the inner flue duct downwards. 4. Push inner flue duct upwards and attach to the fixing brackets on the left and right. Screw flue duct to the sides of the fixing bracket using two Electrical connection screws. [. . . ]