User manual ARTHUR MARTIN AFT629N

[. . . ] This unit must not be used by persons, including children with reduced physical, sensory or mental abilities, or by persons without experience and knowledge unless they are supervised by a person who is responsible for their safety and has been instructed on the use of this equipment. Children must not be unsupervised in the vicinity of the unit and must not play with the unit under any circumstances. Safety Shutdown: If one or more filters are removed, the unit switches off automatically. The unit is operational once again only after the the correct positioning of the filter. [. . . ] The connection to the 230 Volt network as well as the entire installation of the exhaust hood 5 must be at absolute zero potential and conducted by a professional. Workflow: Draw four drill holes on the ceiling and then drill the four holes. Insert the four dowels, screw in the four hanger bolts, and screw the four decorative discs onto the hanger bolts. Workflow: Thread the cable suspension with the cable clamp from above into the hood body. Screw the cable clamp into the mounting and secure with the set screw. Workflow: Now screw the four wire cables with the cable supports onto the hanger bolts. Now the steel cable can get twisted but it will `untwist` during workflow 7. Workflow: The wire cable relaxes and the length of the steel cable can be varied by exerting pressure onto the cable clamp. Uncover the hood after installation only so that no dirt particles can reach the top of the hood. The unit can be uncovered again only once the kitchen has been completely set up and the final cleaning has taken place. 7 Remove protective box from UV-C lamp (13) Insert the stainless steel filter (586x324 mm) (14) into the hood body (1) Please ensure that the filter is correctly inserted!This way, the risk of fire is minimized and optimal function is maintained. With increasing saturation of fatty residues, the risk of fire increases and the function of the unit can be impaired. Remove the activated carbon insert and the thumb screws before cleaning!The metal grease filter (7/14) must be cleaned every 8 to 10 weeks under normal operating conditions (2-3 hours daily) Cleaning should be done with the cleaner which is included with the exhaust hood however the cleaning can be done in the dishwasher depending on the size of the filter. The cleaning intervals for the metal filter (7) on the top side of the hood body are shorter during the heavy pollen season. However, it can be attacked by soda and caustic sode so that a brown discoloration can occur. The frame and the cover sheet of this metal filter is made of stainless steel. When cleaning by hand, rinse the filter several times in hot, soapy water. Exchanging activated carbon The unit must be disconnected from the mains before it is opened!The frequency with which the activated carbon is to be exchanged is between three months and one year, depending on frequency of use. Fold grease collector (11) down Remove stainless steel filter (14) Loosen the two thumb screws Remove stainless steel frame and then remove carbon cartridge Loosen the two thumb screws again on the carbon cartridge and then replace the old carbon with the new carbon Tighten the previously loosened thumb screws Insert the stainless steel filter (14) into the hood body Page 11 Removable carbon catrid- Stainless steel filter with carbon cartridge (rear side) Stainless steel For loose activated carbon 11. [. . . ] This product is in compliance with · The security objectives of the "Low Voltage" guideline EG/73/23 · The protection requirements of the "EMC" EG/336/89 guideline as amended by EG/68/93 guideline, built and brought onto the market. Information Information on the Heat Detector (10): We care about your safety. For this reason, we have installed a heat detector into the air cleaning center which functions as follows. If a temperature between 69° C and 71° C is reached under the exhaust hood, the alarm rings automatically and the unit`s power supply is interrupted. [. . . ]