User manual ARTHUR MARTIN ASL5368LA

[. . . ] Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference. Children and vulnerable people safety · This appliance can be used by children aged 8 years and Above and by persons with reduced capabilities provided that they have been given instruction and/or supervision regarding the safe use of the appliance and understand the potential hazards involved. [. . . ] The display shows the current Press the on/off button to confirm the AirDry improves the drying results with less energy consumption. Do not try to close the appliance door within 2 minutes after automatic open. To improve the drying performance refer to the XtraDry option or activate AirDry. The display shows the current Press the on/off button to confirm the setting. Desired options must be activated every time before you start a programme. It is not possible to activate or deactivate options while a programme is running. If you have selected non compatible options, the appliance will automatically deactivate one or more of them. With the use of this option, the duration of some programmes, water consumption and the last rinse temperature can be affected. The XtraDry option is a permanent option for all programmes other than Eco 50° and need not to be selected at every cycle. In other programmes the setting of XtraDry is permanent and it is automatically used in next cycles. If the option is not applicable to the programme, the related indicator does not come on or it flashes quickly for a few seconds and then goes off. timeManager This option increases the pressure and the temperature of the water. The washing results are the same as with the normal programme duration. If the option is not applicable to the programme, the related indicator does not come on or it flashes quickly for a few seconds and then goes off. Make sure that the current level of the water softener agrees with the hardness of the water supply. When you start a programme, the appliance can take up to 5 minutes to recharge the resin in the water softener. The salt is used to recharge the resin in the water softener and to assure good washing results in the daily use. Turn the cap of the salt container clockwise to close the salt container. After you fill the salt container, immediately start a programme to prevent corrosion. How to fill the rinse aid dispenser Only use rinse aid specifically designed for dishwashers. Pour the rinse aid in the dispenser (A) until the liquid reaches the fill level 'max'. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam. [. . . ] The majority of problems that can occur can be solved without the need to contact an Authorised Service Centre. The remaining time in the display increases and skips nearly to the end of program time. If the delay start is set, cancel the setting or wait for the end The appliance has started the procedure to recharge the resin inside the water softener. If the delayed start option is set, cancel the delay setting or wait for the end of the countdown. [. . . ]