User manual ARTHUR MARTIN ASL64050

[. . . ] Com Contents Safety information Product description Control panel First use Setting the water softener Use of dishwasher salt Use of rinse aid Daily use Loading cutlery and dishes Use of detergent Multitab function Select and start a washing programme 2 4 5 6 6 7 8 9 10 12 13 14 Subject to change without notice Unloading the dishwasher Washing programmes Care and cleaning What to do if. Technical data Hints for test institutes Installation Water connection Electrical connection Environment concerns 15 16 17 18 19 20 21 21 22 22 Safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. [. . . ] They can also contain other different agents depending on which kind of tablets you choose ('3 in 1', '4 in 1', '5 in 1' etc. Once this function is selected it will remain active for all following wash programmes. With the selection of this function the inflow of rinse aid and salt from each respective supply container is automatically deactivated and also the indicator lights for salt and rinse aid are deactivated. Activate/deactivate the multitab function before the start of a washing programme. Once the programme is running, the multitab function can NO longer be changed. If you want to cancel the multitab function you have to cancel the programme setting and then deactivate the multitab function. In this case you have to set a washing programme (and desired options) again. Activation/deactivation of the multitab function Simultaneously press and hold the two multitab buttons (function buttons D and E) until the multitab indicator light comes on. To deactivate the function press the same buttons again until the indicator light corresponding to the multitab function symbol goes off. The activation/deactivation of the rinse aid is only possible with the multitab function active. Press function button B, the lights of function buttons A and C turn off while the light of function button B continues to flash. To change the setting, press button B again, the digital display shows the new setting. To memorize the operation, switch off the dishwasher by pressing the on/off button. If you decide to revert back to the use of individual detergents we advise that you: 1. Adjust the water hardness setting to the highest setting and perform 1 normal washing programme without loading any dishes. Adjust the water hardness setting according to the hardness of the water in your area. Select and start a washing programme Select the washing programme and delay start with the door slightly opened. The start of the programme or the countdown of the delay start will occur only after the closure of the door. Check that the baskets have been loaded correctly and that the spray arms are free to rotate. Press the button corresponding to the required programme (refer to 'Washing programmes' chart). After having selected the washing programme, press the delay start button until the flashing number of hours for the delay start shows in the digital display. Close the door, the countdown will continue from the point at which it was interrupted. [. . . ] DO NOT use connection hoses which have previously been used on an old appliance. This appliance has been fitted with safety features which will prevent the water used in the appliance from returning back into the drinking water system. Water drain connection The end of the drain hose can be connected in the following ways: 1. To the sink outlet spigot, securing it to the underside of the work surface. [. . . ]