User manual ARTHUR MARTIN AWT6020W

[. . . ] ⷠIf the appliance is installed on carpeted floor, ensure that the carpet does not obstruct any ventilation ducts located at the base of the appliance. ⷠThe appliance must be equipped with an earthed power plug which conforms to regulations. ⷠBefore connecting your appliance to the power supply, carefully read the instructions in the chapter entitled "Electrical connection". ⷠReplacing the power cable should only be carried out by an authorised service engineer. [. . . ] "Delay start" pushbutton You can change or cancel the delayed start time at any time before you press the "Start/Pause" pushbutton by pressing the "Delay start" pushbutton again (when all indicators are off, the wash programme will start immediately). If you have already pressed the "Start/Pause" pushbutton and you want to change or cancel the delayed start, proceed as follows : · To cancel the delay start and start the cycle immediately, press "Start/Pause" and then "Delay start" . To change the timer delay period, you must go through the "Stop" position and reprogramme your cycle. If you need to open it, you must first pause the appliance by pressing the "Start/Pause" pushbutton. After closing the lid again, press the "Start/Pause" pushbutton. Start of the programme Press the "Start/Pause" pushbutton to start the cycle ; the corresponding light will come on green. It is normal for the programme selector to remain stationary during the cycle. Before closing the lid of your appliance, ensure that the drum is properly closed : · When the two shutters are closed, · locking button A released. Proportioning of detergents Pour the amount of washing powder into the washing and prewash compartments if you have selected the "prewash" option. Selecting the spin speed Press the "Spin" pushbutton to change the spin speed, if you want your washing to be spun at a different speed to the one selected by the appliance. Or "Night silence plus" The maximum speed is 600 rpm for all the programmes. Selecting options You must select the different options after selecting the programme and before pressing the "Start/ Pause" pushbutton (see "Programmes table"). If one of the options is not compatible with the selected programme, the "Start/ Pause" pushbutton flashes red. Electrolux 13 : End of cycle Interrupting a programme Adding washing during the first 10 minutes Press the "Start/Pause" pushbutton : the corresponding light will flash green while the appliance is paused. The lid can only be opened around 2 minutes after the washing machine has come to a stop. Press the "Start/Pause" pushbutton again to continue the programme. End of the programme The washing machine stops automatically, the "Start/Pause" pushbutton goes out and the light "End of cycle" comes on. The lid can only be opened around 2 minutes after the washing machine has come to a stop. Standby mode If the appliance is on but no commands are selected for 10 min before or after a cycle, it goes into standby mode. Normally soiled work clothes, bed linen, table linen, body linen, towels. [. . . ] Dispose of them at a waste collection site (enquire at your local council) for collection and recycling. When disposing of your appliance, remove all parts which could be dangerous to others: cut off the power supply cable at the base of the appliance. The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. [. . . ]