User manual ASUS M4N68T V2

[. . . ] If this Eric Lu equipment does cause interference to radio or television equipment reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: DECLARATION OF CONFORMITY Per FCC Part 2 Section 2. Address: 18305 Valley Blvd. , Suite#A LA Puent, CA 91744 Phone/Fax No: (818) 854-9338/ (818) 854-9339 hereby declares that the product Product Name: Mother Board Model Number: GA-6VM7-4E Conforms to the following specifications: FCC Part 15, Subpart B, Section 15. 107(a) and Section 15. 109(a), Class B Digital Device Supplementary Information: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful and (2) this device must accept any inference received, including that may cause undesired operation. 9, 2001 -Reorient or relocate the receiving antenna -Move the equipment away from the receiver -Plug the equipment into an outlet on a circuit different from that to which the receiver is connected -Consult the dealer or an experienced radio/television technician for additional suggestions You are cautioned that any change or modifications to the equipment not expressly approve by the party responsible for compliance could void Your authority to operate such equipment. [. . . ] In "Advanced Mode", one can change the system bus speed in small increments to get ultimate system performance. And no matter which mainboard is used, if it's a Gigabyte's product*, EasyTuneIII helps to perform the best of system. Besides, different from other traditional over-clocking methods, EasyTuneIII doesn't require users to change neither BIOS nor hardware switch/ jumper setting; on the other hand, they can do "overdrive" at only one click. Therefore, this is a safer way for "overdrive" as nothing is changed on software or hardware. If user runs EasyTuneIII over system's limitation, the biggest lost is only to restart the computer again and the side effect is then well controlled. Moreover, if one well-performed system speed been tested in EasyTuneIII, user can "Save" this bus speed and "Load" it in next time. Obviously, Gigabyte EasyTuneIII has already turned the "overdrive" technology toward to a newer generation. This wonderful software is now free bundled in Gigabyte motherboard attached driver CD. Users may make a test drive of "EasyTuneIII" to find out more amazing features by themselves. 44 6VM7-4E Motherboard Memory Installation The motherboard has 2 dual inline memory module (DIMM) sockets. To install the memory module, just push it vertically into the DIMM Slot . The DIMM module can only fit in one direction due to the two notch. Install memory in any combination table: DIMM DIMM 1 DIMM 2 168-pin SDRAM DIMM Modules Supports 16 / 32 / 64 / 128 / 256 / 512 MB Supports 16 / 32 / 64 / 128 / 256 / 512 MB X 1 pcs X 1 pcs Total System Memory (Max 1GB) 45 BIOS Setup Page Index for BIOS Setup The Main Menu Standard CMOS Setup BIOS Features Setup Chipset Features Setup Power Management Setup PNP/ PCI Configuration Load BIOS Defaults Load Setup Defaults Integrated Peripherals Hardware Monitor Supervisor Password / User Password IDE HDD Auto Detection Save & Exit Setup Exit Without Saving Page P. 48 P. 50 P. 53 P. 55 P. 58 P. 61 P. 62 P. 63 P. 64 P. 66 P. 68 P. 69 P. 70 P. 71 46 6VM7-4E Motherboard BIOS Setup BIOS Setup is an overview of the BIOS Setup Program. If you select User Type, related information will be asked to enter to the following items. Enter the information directly from the keyboard and press <Enter>. Such information should be provided in the documentation form your hard disk vendor or the system manufacturer. Number of cylinders HEADS number of heads PRECOMP write precomp LANDZONE Landing zone SECTORS number of sectors If a hard disk has not been installed select NONE and press <Enter>. · Drive A type / Drive B type The category identifies the types of floppy disk drive A or drive B that has been installed in the computer. No floppy drive installed 5. 25 inch PC-type standard drive; 360K byte capacity. 5. 25 inch AT-type high-density drive; 1. 2M byte capacity (3. 5 inch when 3 Mode is Enabled). 3. 5 inch double-sided drive; 720K byte capacity 3. 5 inch double-sided drive; 1. 44M byte capacity. 3. 5 inch double-sided drive; 2. 88M byte capacity. 51 BIOS Setup · Boot Sector Virus Protection If it is set to enable, the category will flash on the screen when there is any attempt to write to the boot sector or partition table of the hard disk drive. The system will halt and the following error message will appear in the mean time. Enabled Activate automatically when the system boots up causing a warning message to appear when anything attempts to access the boot sector or hard disk partition table No warning message to appear when anything attempts to access the boot sector or hard disk partition table. (Default Value) Disabled · Memory The category is display-only which is determined by POST (Power On Self Test) of the BIOS. Base Memory The POST of the BIOS will determine the amount of base (or conventional) memory installed in the system. [. . . ] Click "@BIOS Writer v1. 05" Click " " . Click Here. Methods and steps : I. Select @BIOS sever ( "Gigabyte @BIOS sever 1 in Taiwan" and "Gigabyte @BIOS sever 2 in Taiwan" are available for now, the others will be completed soon) d. System will automatically download and update the BIOS. 77 Appendix II. Please select "All Files" in dialog box while opening the old file. [. . . ]