User manual ATLANTIC BOITIER MURAL FIL PILOTE

[. . . ] In the case of installation without an energy controller: In the case of installation with an energy controller: Please refer to the controller's manual. This is the mode to which the box returns after a time period only if there is no programming card. Every time you switch on, the upper display shows "Mod" and the indicator light for the memorised default mode flashes rapidly. For ten seconds, you can alter the mode by pressing the mode change key. [. . . ] The green indicator light is then permanently lit and the lower display flashes 2 seconds later. Lower display Adjustment keys If you wish to set a timed mode, use the keys to set the number of hours or days depending on the mode you select. Example of using a permanent or timed mode : Permanent mode : to keep a mode the same throughout the day or every day. For example, when the heating season ends, keep to Frost mode until the next season. Timed mode : to maintain a particular temperature depending on how long you will be away. For example, at night we would recommend Eco mode so that you sleep better (heat disturbs your sleep). If you are going away on holiday for a few days, we recommend that you programme the length of Frost mode so that you can return to a comfortable temperature. By holding down both keys simultaneously, you can read, for information only, the temperature measured on the wall box where it is located. If you notice a difference between the temperature displayed and your reference thermometer, you can adjust the display via the wheel on the back of the fascia. This enables you to automate the electric heating to suit your lifestyle. However, your wall box allows you to suspend the programme momentarily. The programming card automates the changeovers between Comfort and Eco modes. Therefore, if you are in a Comfort period, the green indicator light remains permanently lit in Comfort mode. If you are in an Eco period, the green indicator light remains permanently lit in Eco mode. suspending the programme This enables you to suspend the current programming temporarily. Using the Mode Change key, set the green indicator light to the mode you wish (Comfort, Medio, Moderato or Eco). This light flashes to indicate that you have left your normal programming and therefore have started suspension. You can select how long you wish to suspend the programme, from 1 to 48 hours, on the lower display. If no period is set, the suspension will last until the next programme change on the programming card. Important: If you have selected Frost mode, the green light remains permanently lit because this mode has priority over the programming. It lasts the number of days selected or, by default, until a different mode is selected. Monday, Tuesday, Thursday and Friday: COMFORT mode from 06:00 to 09:00, and from 17:00 to 23:00. [. . . ] Then set the programming for each zone (see Page18, How to programme the card 1 zone). Press down the validation key and then pres the modification key to set the programming card in Child Safety mode (the keys are then deactivated). The battery must be changed when the battery symbol is displayed (button-style battery CR 2032). Take care not to let any foreign bodies penetrate into the wall box when it is without is programming card. [. . . ]