User manual AUDIOVOX CTV-5060

[. . . ] If you are unsure of regulations regarding this, please consult your local laws to determine how this applies to you. · Users should be aware of possible noise distraction caused by the use of the product and should carefully monitor the volume so as not to interfere with the driver's attention to surrounding traffic conditions. FUNCTION-------------------------------------------------------1 2 FIG. POWER ON / STAND BY key AUTO PROGRAM key TV / AV1 / AV2 key PICTURE SELECT key VOLUME DOWN key (PICTURE SELECT DOWN) VOLUME UP key (PICTURE SELECT UP) CHANNEL DOWN key CHANNEL UP key ROD ANTENNA 12 4 567 8 9 10 11 FIG. [. . . ] Move the TRANSMITTER OFF / FM1 / FM2 switch (13) to "FM1" (or "FM2"). Turn on the FM radio and set the same channel frequency to receive FM1 (or FM2) signal. When the function is unused, move the switch (13) to "OFF". 3 TV OPERATION------------------------------------------------1. Pull out the ROD ANT (2) or connect an external antenna to ANT jack (14) for better reception. Used in the vehicle, the diversity unit (with boost function) is recommended to use to improve the reception performance. 3. Press the AUTO PROGRAM key (5, 34) to scan the whole channels and memorize them. Press the CHANNEL UP (11, 40) or DOWN (10, 39) key to select the desired TV station. If the ROD ANT (12) is used, adjust the antenna direction to get the best quality of reception. The recommended viewing angle of the TV unit is +30° ~ -10° vertical and +45° ~ -45° horizontal. 4 8. Picture Adjustment 1) Press the PICTURE SELECT key (35) several times, the screen will appear the picture control bar in the following order sequentially. 2) Before the disappearance of the PICTURE SELECT UP (VOLUME UP) (9, 38) or DOWN (VOLUME DOWN) key (8, 37), to adjust the picture quality. For example, COLOR DOWN UP 3) Press the PICTURE RESET key (36) on the remote control unit to recover the original picture setting. Audio Operation 1) Press the VOLUME UP (9, 38) or DOWN (8, 37) key to adjust the volume output level. If the channel number displayed on the screen is red (it means the channel has not been memorized), the volume control is in vain. 3) No volume output when the MUTE key (32) on the remote control unit is pressed. [. . . ] In locations with poor reception, it may not be possible to get a clear picture or any picture at all. Adjust brightness · · Sound heard but picture all white or dark Sound heard but color light Picture visible but no sound · · · · · Brightness control not set correctly Color control not set correctly. Volume control turned too low Earphone inserted · · · · · Adjust color. [. . . ]