User manual BEKO CFB6433

[. . . ] The minimum safety distance Between the cooker top and the extractor hood is 650 mm (some models can be installed at a lower height, please refer to the paragraphs on working dimensions and installation). Check that the mains voltage corresponds to that indicated on the rating plate fixed to the inside of the hood. For Class I appliances, check that the domestic power supply guarantees adequate earthing. Connect the extractor to the exhaust flue through a pipe of minimum diameter 120 mm. [. . . ] Take it to the collection center for the recycling of electrical and electronic equipment. Please consult your local authorities to learn about these collection centers. The product you have purchased complies with EU RoHS Directive (2011/65/EU). It does not contain harmful and prohibited materials specified in the Directive. Package of the product is made of recyclable materials in accordance with our National Legislation. Do not dispose of the packaging materials together with the domestic or other wastes. Take them to the packaging material collection points designated by the local authorities. 1 When used in the extraction Mode, the cooker hood ducting must not be connected to a flue which is used for exhausting fumes from appliances supplied with energy other than electric, such as a central heating flue or water heating flue. During winter supply ensure that the mains Time it may be convenient to use voltage corresponds with the The hood in the recycling mode to voltage on the rating plate Avoid heat loss from the kitchen. 3 Connect the cooker hood to the Consideration should be given to mains via a double poled switch The difficulties that can be found during installation. Work must be undertaken by a qualified and competent person in conformity to the rules concerning the evacuation of contaminated air. The manufacturer disclaims all liability for any damage or injury caused as a result of not following the instructions for installation contained in the following text. 4 For cooker hoods featuring an earth cable, make sure the electric plant of your house is correctly earthed. 5 Appliance in class II are provided with a double insulation; therefore do not connect them through earthed plugs but through a double poled plugs. 6 When installed, the hood must It must be replaced by a special From the manufacturer or its Disconnect the hood from the 10 If the room where the cooker hood is to be used contains a fuel burning appliance such as a central heating boiler then this must be of the room Knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. To ensure that they do not play Are fitted, ensure that there is Hood is used in conjunction with appliances supplied with energy other than electric, the negative pressure in the Room must not exceed 0, 04 mbar to prevent fumes being drawn back into the room by 11 The appliance must be positioned so that the plug is accessible. Some installation systems require the opening and removal of the metal grille panel. 1 Instructions for opening and removing the metal grille panel To open the grille panel, press inwardly on the two slider catches at each side of the grille panel and the grille will pivot down. To remove the metal grille, pull forward on the right hand side so that the hinge pin on the back of the grille will be released from the slot in the side of the casing. Predrilled wall cabinet: fix the hood onto the wall cabinet base panel using the four screws 4. - If the hood is provided with a paper fixing template, follow the instructions. - If the hood is not provided with a paper fixing template, position the hood on the wall cabinet base panel and pilot drill the 3. [. . . ] 1- The violet colour of the dots, which are Visible through the metal grille, is spread over the whole surface of the filter. 2- The red colour of the stripes, which is not visible through the metal grille when the filter is clean, becomes visible from the outside of the metal grille. It should be washed once a month in hot water using mild detergent or liquid soap. WARNING: An excess of grease in the filter not only would affect the a performance of the hood , but it is also a possible fire risk. [. . . ]