User manual BEKO HCA92640BH

[. . . ] This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge. Children should be supervised to ensure that they do not play with the appliance. Disconnect the product from the mains during installation, maintenance, cleaning and repairing procedures. If the power cable is damaged, it must be replaced by the manufacturer, after sales service or a similarly qualified person (preferably an electrician) or someone designated by the importer in order to avoid possible risks. [. . . ] Do not dispose of the package waste together with the household waste or other waste and deliver them to the package collection points indicated by the local authority. Control Lamp power Air outlet pipe Capacity Motor power Total power Net weight Colour Values stated on the product labels or in the documentation accompanying it are obtained in laboratory conditions in accordance with relevant standards. These values may vary depending on operational and environmental conditions of the product. Width Depth Height Supply voltage Control Lamp power Air outlet pipe Capacity Motor power Total power Net weight Colour Width Depth Height Supply voltage Control Lamp power Air outlet pipe Capacity Motor power Total power Net weight Colour Please consult the nearest Authorised Service Agent for the installation of your hood. A Remove the protective film (if any) on the hood and flue surface after the installation. Distance between lower surface of the hood and upper surface of the hob should be at least 65 cm. Install your appliance so that you can reach the power connection (plug, outlet) easily after installation. Information required for the preparation of the installation place for your hood is given below. 2 Installing the hood onto the wall To install the hood onto the wall, loosen the screws of hanger plates on the motor housing and pull the plates upwards. Secure the Ø 150 mm plastic flue adapter onto the top of the body with 3. If you will use Ø 120 mm flue pipe, install Ø 120 mm flue adapter onto it. Affix the installation template onto the installation place of the hood. Drill the points market with (X, Y) (Figure 5) using a Ø 10 mm bit and points market with (Z) (Figure 5) using a Ø 6 mm bit. Bottom surface of the appliance Hammer Ø 10 mm wall plugs (X, Y) into the holes drilled for hanger screws. Hammer 2 x Ø 6 mm wall plugs (Z) into the holes drilled with a Ø6 mm bit for the external flue connection plate. 5x60 hanger screws into the Ø 10 mm wall plugs (Y) you have hammered into the wall. (Figure 6) Connect the internal flue connection plate to the 6 mm wall plugs (Z) on the wall using Ø 3. Open the side suction window of the hood by pulling it towards yourself. 5x60 screws through the X holes located inside in order to secure the appliance. Disconnect the product from mains supply before starting flue installation. Screw the external flue to the external flue connection plates located on the motor housing. Extend and screw the internal flue from its outer edges onto the flue connection plate which was secured to the wall (Figure 8). [. . . ] Using them to illuminate the ambient/kitchen will result with unnecessary power consumption and inadequate illumination. For a better performance, we advise you to use low speeds in normal conditions, and high speeds when smell and vapors are intensified. You can start the hood by pressing the desired speed level key (B, C, D). Prior to cleaning and maintenance, unplug the appliance or turn the main switch off or loosen the fuse that supplies the hood. [. . . ]