User manual BEKO VRR 60110 VW

[. . . ] Do not immerse the appliance informed about the operation of Or its power cord in water for the appliance. The children shall be supervised Do not disassemble the to prevent them from playing Use only original parts or · Parts recommended by the the battery pack before any Not vacuum cement, plaster or a damaged adaptor shall be Use the appliance with the the authorised representative of adapter delivered with the the manufacturer or a similarly Do not use the appliance without · Keep your fingers, hair and loose Clothes away from moving parts If you keep the packaging mate- or clearances while vacuuming. Rials, keep them out of the reach · Batteries shall be removed from The appliance before discarding This appliance is not intended the appliance. Disconnect the appliance from Children, with physical, sensory power supply before removing Who have not adequate experi- · Its use, unless they are under the regulations. [. . . ] If the adapter is unplugged or power outage occurs when the appliance is in the charging unit (14), the appliance will leave the charging stand without a cleaning mode selected and c start searching for the charging station. In this case, turn the appliance off using the power button on the side (6). When the power outage is over or you plug in the adapter, turn the power on and send the appliance to the charging unit using the controller (15) or the mobile application and wait for it to settle. C The indicator on the appliance will blink in red colour while charging. C After completely charging, the indicator on the appliance will remain in blue colour. C When the battery is low in standby mode, the indicator will blink twice in a second. C When the battery is low in cleaning mode, the appliance will find the charging unit (14) Press the "AUTO" button on Or; press the "Start/stop" Cleans the entire area following a zigzag cleaning route. At the end of cleaning, the robot will return to the charging station. Press the "MODE" button on the remote controller until "MODE1" is displayed on the screen. The appliance cleans the edges of the wall and remains clear of the charging unit (14) to avoid crashing during operation. At the end of cleaning, the appliance will return to the charging unit. Press the "MODE" button on the remote controller until "MODE2" is displayed on the screen. Press the "MODE" button on the remote controller until "MODE3" is displayed on the screen. The appliance will switch to the mode of cleaning the 2m*2m area that it is located. mODE3 The appliance will switch to random cleaning mode and will clean the room following a random route. Cleaning will continue until the appliance runs out of battery, then it will move to the charging unit (14) to recharge. Press the "MODE" button on the remote controller until "MODE4" is displayed on the screen. The appliance will operate two laps of cleaning by following a zigzag route. At the end of cleaning, the appliance will return to the charging unit (14). Press on the "MAX" button on the remote controller (15) to start the maximum level cleaning while the appliance is in standby or cleaning mode. When you successfully set the scheduled cleaning timing, the appliance will start cleaning automatically at the scheduled time. To enter the scheduling mode, push and hold the "CLK" button on the remote controller (15). [. . . ] Only the dust container may be completely dry, attach the filter C Clean regularly according to the amount of dust accumulated. Clean the sensor and the Clean the charging contact Wheels using a soft fiberglass points on the charging unit (14) Using a soft, fiberglass cloth. 3 Cleaning the rotating brush group Clean the charging contact points on the appliance using a soft, fiberglass cloth. Note: After washing, please wait until the rotating brush group is completely dry. [. . . ]