User manual BEST ZETA HF

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual BEST ZETA HF. We hope that this BEST ZETA HF user guide will be useful to you.


BEST ZETA HF : Download the complete user guide (4797 Ko)

Manual abstract: user guide BEST ZETA HF

Detailed instructions for use are in the User's Guide.

[. . . ] The appliance must be installed by a qualified person in compliance with the instructions provided. Wear gloves when carrying out installation and maintenance operations. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. Warning: Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards. [. . . ] To set the desired sensitivity press one of the buttons C, Dor E (min, med, max). Operation as traditional hood: if in automatic mode, press the button B to change to manual mode; the LED B goes off. Press one of the buttons C, D or E to start the motor in 1st, 2nd or 3rd speed, respectively. P2: It starts the engine setting it to the first speed (the icon is highlighted). P3: It starts the engine setting it to the second speed (the icon is highlighted). P4: It starts the engine setting it to the third speed (the icon is highlighted). P5: It starts the engine setting it to the fourth speed (the icon is blinking). The maximum speed is set to be maintained for maximum 5 minutes, after this time the speed will be automatically adjusted to the third speed. By running the timer (5 minutes), the engine stops automatically after 5 minutes. After 30 hours of operation the icon is highlighted to indicate that the filter should be cleaned. After 120 hours of operation the icon is highlighted to indicate that the grease filter should be cleaned and the charcoal filters - replaced. To RESET the alarm, press the icon while it is highlighted (or while it is blinking). It can be varied on your keyboard (for cleaning) with a long press of the buttons P1 and P7 simultaneously. To exit cleaning is necessary to activate the buttons again P1 and P7 pressed simultaneously (long), or wait for 5 minutes. 45-46 Button TC1 (Lights): Switches main light ON/OFFWhen the main light is on, BL1 changes colour and becomes active. When the button is pressed for more than a second, it switches the courtesy lights (optional) on/off. When the motor is active, the LED of the last selected button (TC2-TC5) active to signal which speed has been set. button TC6 (Auto ASC)Activates/deactivates the automatic ASC function. In this mode, motor speed increases or decreases depending on the quantity of smoke and odours being produced under the hood. Each time that the motor changes speed, either automatically or forced by the user, BL6 lighting blinking for a few seconds. 30h filter ALARM: After 30 hours of operation, an alarm switches on to signal the need for anti-grease filter cleaning. The filter alarm, when active, is displayed for 30 sec each time the motor is deactivated:BL6 remains ON. [. . . ] Comply with the official instructions provided by the competent authorities in merit when installing the disposal duct (example, the air collected must not be conveyed into a duct already used to central heatings systems, thermosiphons, etc. Correction: make sure nothing is blocking the vent (bird nests or kinks in the duct work). Correction: Make sure the tape is removed from the damper blades and that it swings open freely. For filtering hood Possible cause: the charcoal filter/s is saturated. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE BEST ZETA HF




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual BEST ZETA HF will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.