User manual BIKE FRIDAY DUALDRIVE

[. . . ] If your Bike Friday is equipped with different shi levers, the le hand lever controls the internal hub. Pulling the cable in shis the hub to a higher gear for descending hills. For those who are curious about the gear ratios, adjust your gear inches for low gear by 73%, mid-range 100% (1:1), and high gear 136%. If You Need Help . . If you need technical assistance with any Green Gear Cycling product or are unclear on the proper operation of your Bike Friday, please call us and a Service Technician will help you get back on the road. [. . . ] Start by shiing the DualDrive hub into the lowest gear (uphill icon, or repeatedly press the small lever on STI shiers). DualDrive Hub 4. Shifting Rod Underneath the click box is a small screw head called the shiing rod. Normally you do not need to remove this rod to remove the wheel. Tighten Loosen 2. Attachment Button The small black buon on the click box is used to aach the box to the axle. To remove the click box, press this buon down until it is flush with the top of the Fig. If you need to remove the rear wheel to pack your bike, either remove the rod and keep it in a safe location or put the protector sleeve (required for only a few bike models) over the axle and pin head. If you wish to add some oil to the hub, remove the shiing rod and dip or coat the rod with good quality oil. When screwing the shiing rod back into the hub, be careful not to over-tighten. Just lightly tighten the shiing rod with a flat screwdriver, until snug. Fig. Removing Rear Wheel With the click box removed, loosen the two axle nuts with a 15mm wrench, a crescent wrench, or your pedal/headset wrench in the tool pouch. Remove Click Box With the black buon down, the click box should just slide off of the axle end. The click box will remain connected to the shi cable. Loosen Tighten The axle washers have a tab Fig. When reinstalling the rear wheel, place the washers on the outside of the drop outs (the part of the frame which holds the wheels), with the tab pointed down and facing toward the wheel. With the axle properly seated in the drop outs, tighten the axle nuts securely. Fig. 3 Click box button down (detach). Do not forget to reconnect the brake aer installing the wheel! 4 www. bikefriday. com 800-777-0258 · +1-541-687-0487 800-777-0258 · +1-541-687-0487 www. bikefriday. com 5 DualDrive Hub 6. Reattaching Click Box To reaach your click box to the axle, first ensure the black buon is all the way down, flush with the top as in Figure 3. If you cannot get the buon down, it is because the shi cable pulled the small black shiing fork (circled in Figure 6 and 6a) Fig. First, make certain the shi cable housing is properly seated at the shi lever, any cable stops, and in the click box barrel adjuster. down, push the fork tip down toward the hole in the box with your finger while applying pressure to the black buon. You may need to keep your finger on this buon to keep it from popping up from cable movement. DualDrive Hub 8. First shi the DualDrive into the middle gear (flat terrain, or middle STI position). On top of the click box is a small clear window showing a couple of ladder-like bars over a brightly colored Fig. [. . . ] This warranty applies only to the original owner and is not transferable. Claims must be made through Green Gear Cycling or an authorized dealer. This warranty covers bicycles and components purchased outside of the United States only if purchased through an authorized Green Gear Cycling dealer. This warranty does not cover normal wear and tear, improper assembly or maintenance, folding or unfolding, or installation of parts or accessories not originally intended or compatible with the bicycle as sold. [. . . ]