User manual BRANDT AD 1186 X

[. . . ] Do not use it for commercial or industrial purposes or for any other purpose than that for which it was designed. € Do not modify or attempt to modify any of the characteristics of this appliance. € Always unplug the hood before cleaning it or performing other maintenance acts. € Provide adequate ventilation for the room in the case of simultaneous use of the hood and other appliances powered by an energy source other than electricity. [. . . ] If the power cable is damaged, call the aftersales service department in order to avoid danger. Warning If the electrical installation at your residence requires any changes in order to hook up your appliance, call upon a professional electrician. Warning If the hood displays any malfunctions, unplug the appliance or remove the fuse corresponding to the electrical socket where your appliance is plugged in. 8 2 / INSTALLING YOUR APPLIANCE • ASSEMBLING THE HOOD Warning The hood must be installed in compliance with all applicable regulations concerning the ventilation of premises. In particular, the evacuated air should never be conveyed to a duct used to evacuate smoke from appliances that use gas or other combustible fuels. Unused ducts may only be used after approval from a competent specialist. The minimum distance between the cooking surface and the lowest part of the hood must be 70 cm at least. If the instructions for the hob installed under the hood specify a distance of more than 70 cm, this requirement must be respected. EN Pict 1 Fixing to the wall : — Mark a vertical line on the wall centred on the cooktop. € Mark on the wall the three holes that have to be drilled, using the supplied hood suspension hook and observing the recommended distance. € Drill the three 8 mm diameter holes in a suitable position and insert the plugs (part A Pic. € Before fixing the hood, mount the nonreturn valve on the motor outlet -Secure the hood’s fixing support, ensuring that it is perfectly level. 1) — Fix the extendable evacuation sleeve (not included) to the motor outlet without impeding the movement of the non-return valve. € Fit and secure the body of the hood on this support with the screws provided for this purpose. Pict 2 EN 2 / INSTALLING YOUR APPLIANCE • ASSEMBLING THE VENTILATION SHAFT • Outdoor evacuation — Calculate the final height for fixing the duct support U-bracket (part B Pic. 1) — Mark the two holes accordingly — Drill 8 mm diameter holes and secure the duct support bracket, ensuring that it is fixed on the same axis as the hood (part B Pic. Slide the glass in and secure it with the 4 screws with rubber seal (glass safety). € Make the electrical connection to the hood using the mains supply cable. € Lift the upper duct up to the ceiling and fix it to the bracket using the screws. Pict 4 Pict 3 10 2 / INSTALLING YOUR APPLIANCE • Recycling — Calculate the final height for fixing the duct support U-bracket (part B Pic. Warning Failure to respect the guidelines for cleaning the appliance and filters may cause fires. € CLEANING THE FILTER CARTRIDGES They must be cleaned after approximately 30 hours of use or at least once a month. [. . . ] ) - Dette apparatet er ikke ment for bruk av personer ( inkludert bar n) med r eduserte fysiske eller sensoriske evner, eller personer uten erfaring eller kunnskap, med mindre det br ukes v ed hjelp av e n person som er ansvarlig for deres sikkerhet, eller under oppsyn. Kontakt rådhuset eller forhandleren for innsamlingspunkt for brukte apparater nærmest ditt hjem. Hvis strømkabelen er skadet, ringe avdeling for ettersalgs-service for å unngå fare. Trykk på knappen "Lys" for å skru på lyset Trykk på knappen igjen for å skru av lyset. [. . . ]