User manual BRANDT AD1006B

[. . . ] — Respect the recommended frequency of cleanings and filter replacements. € The hood should never be used over a combustible fuel burning stove (wood, coal, etc. € Never use steam or high-pressure devices to clean your appliance (requirement imposed by electrical safety). € With a view to constantly improving our products, we reserve the right to modify their technical, functional or aesthetic characteristics, making any changes to their features considered necessary or desirable in view of technical progress. [. . . ] 21 EN 1 / NOTICES TO THE USER • DESCRIPTION OF YOUR APPLIANCE 22 2 / INSTALLING YOUR APPLIANCE EN — The appliance must be unplugged during installation or when any repairs or maintenance work is being performed. € Ensure that the network voltage corresponds to the voltage noted on the identification plate located inside the hood. € If the electrical installation at your residence requires any changes in order to hook up your Appliance, call upon a professional electrician. € If the hood is being used in evacuation mode, do not connect the appliance to a combustion gas exhaust duct (boiler, chimney, etc. € Under no circumstances should the exhaust duct empty into the attic. € Install the hood at a safe distance of at least 70 cm from an electric, gas or combined cooking hob. € USING THE EVACUATION MODE If you possess an outlet to the exterior (pic. 1) Your hood can be connected to this outlet using a flue (minimum diameter Ø mm that is enamelled, in aluminium, flexible or made of inflammable material). If your flue is less than 125 mm in diameter, you must use the recycling mode. 1 • USING THE RECYCLING MODE If you do not possess an outlet to the exterior (pic. In this case, you should add an active carbon filter which will keep in odours. € Make the electrical connection to the hood using the mains supply cable. € Lift the upper duct up to the ceiling and fix it to the bracket using the screws. Pict 6 Pict 5 Pict 3 Pict 4 26 2 / INSTALLING YOUR APPLIANCE • Recycling — Calculate the final height for fixing the duct support U-bracket. € Drill 8 mm diameter holes and secure the duct support bracket, ensuring that it is fixed in the same axis as the hood. 6) — Make the electrical connection to the hood using the mains supply cable. € Lift the upper duct up to the ceiling and fix it to the bracket using the two screws. Pict 8 EN Pict 6 Pict 4 Pict 5 Tip For optimal use of your appliance, we recommend that you connect the hood to a 150 mm-diameter flue (not delivered with the appliance). In the event that the hood will be operated using outdoor evacuation, you should ensure a sufficient inflow of fresh air to avoid a pressure deficiency in the room. 27 EN 3 / USING YOUR APPLIANCE • DESCRIPTION OF CONTROL PANEL Push button 1. Push the Low button, the buzzer will buzz once, and the motor runs at low speed. Push the Mid button, the buzzer will buzz once, and the motor runs at mid speed. [. . . ] 30 4 / CARING FOR AND CLEANING YOUR APPLIANCE Warning EN Before carrying out any work, the power supply to the hood must be turned off, either by unplugging it or by using the circuit breaker switch. • MAINTAINING YOUR APPLIANCE MAINTENANCE WHAT TO DO Never use metal scouring pads , abrasive products or excessively stiff brushes. Top surface and accessories PRODUCTS/ACCESSORIES TO USE To clean the body and the lighting port, you should use only commercial household cleaning products diluted in water and then rinse using clean water, drying with a soft cloth. Use a commercial household cleaning product then rinse abundantly and dry. [. . . ]