User manual BRANDT FC1141M

[. . . ] The electrical installation must be dimensioned for the maximum power indicated on the reference plate and the electrical socket must have a regulatory earth connection. The mains circuit supplying the oven must have a single-pole cut-off switch with at least 3 mm between contacts. If the power cord is damaged, it must be replaced by the aftersales technical service or by similarly qualified staff, to avoid hazard. Ensure the appliance is unplugged from the mains before replacing the oven lamp, to avoid electric shock. [. . . ] The time will automatically be validated after a few seconds and the countdown will start. 4 Before using your new oven for the first time, heat it up while empty (with no food in it and with the control turned to , for 30 minutes at 250ºC). It may produce some smoke or a bad smell (this is normal and is caused by the oven heating up grease residue etc. When it has cooled down, pre-clean it by wiping the inside with a damp cloth. The oven is equipped with a Standard Tray You may also combine any tray Place the tray on level 1 to catch juice drippings. If the item to be roasted is too large, place tray on the base of the oven. Insert the spit in the item you wish to roast and hold it in place using the two sliding hooks (2. Insert the spit in the hole in the rear wall of the oven and unscrew the handle of the spit so that you can close the door (2. Select the ventilated grill with rotary spit programme and switch on the oven. When roasting is complete, screw the spit handle back on and take it out of the oven. Choose the accessory or accessories to be used and their recommended position, Turn the function selector and select the desired function according to the model (2. Several dishes may be cooked at once without their flavours or smells mixing. This function provides power savings of 25% while maintaining the cooking properties. When you select the cooking function, the oven will recommend the optimum temperature and cooking will begin immediately. You can change this temperature within an upper and lower limit according to the programme selected. In all cases, when the cooking process is complete, turn the function selector dial to (2. After a few seconds the time will automatically be validated and the countdown will begin. 12 Selecting the end time : Select the cooking function, the temperature and the cooking time. The start of cooking will be delayed so that it finishes at the time shown. If you prefer the oven to function without a time limit, turn it to hand position . [. . . ] The oven has been functioning for several hours and has switched off automatically for safety reasons. For long cooking times, switch off the oven 5 or 10 minutes before the end of cooking time. The symbol indicates that the appliance must not be disposed of in traditional bins for domestic waste. Recycling domestic appliances will prevent negative consequences for health and the environment and will allow savings on energy and resources. [. . . ]