User manual BRANDT GE2031W & GE2031E,MV

[. . . ] Of course, in an ongoing effort to satisfy your demands with regard to our products as best as possible, our after-sales service department is at your disposal and ready to listen in order to respond to all of your questions and suggestions (contact information at the end of this booklet). Com where you will find all our products, as well as additional, useful information. BRANDT As part of our commitment to constantly improving our products, we reserve the right to make changes to their technical, functional and/or esthetic properties in line with their technological development. Attention: Before installing and using your appliance, please carefully read this Guide to Installation and Use, which will allow you to quickly familiarise yourself with its operation. [. . . ] If you see any kind of damage, before doing anything else, contact your retailer. In order to easily locate the reference information for your appliance, we recommend that you note these data on the “AfterSales Service Department and Customer Relations” page. • ELECTRICAL CONNECTION Ensure that: - The electrical installation has sufficient voltage. - The diameter of the wires complies with the installation requirements. - Your electrical installation is equipped with 16-ampere thermal-sensitive protection. The electrical connections are made before the appliance is installed in its housing. During installation and maintenance operations, the appliance must be unplugged from the electrical grid; fuses must be cut off or removed. The oven must be connected with a power cable (standardized) with three 1. 5 mm2 conductors (1 ph + 1 N + ground) that must be connected to a monophase 220-240 V network via a CEI 60083 standardised receptacle (1 ph + 1 N + ground lead) or in accordance with installation rules. The safety wire (green-yellow) is connected to the appliance’s terminal and must be connected to the ground lead of the electrical set-up. 30 Warning: We cannot be held responsible for any accident resulting from an inexistent, defective or incorrect ground lead. Do not remove the light brown Mica cover that is attached on the right side to the oven cavity to protect the magnetron. Select a level surface that provide enough open space for the intake and/or outlet vents (no built in). € It is mandatory to use a power point with a ground terminal, connected in accordance with current safety regulations. gril Display G- 1 Turn the function selector to set cooking time. 8 :30 Example: If you want to use grill power to cook for 10 minutes, you can operate the oven as the following steps. G- 1 10 :0 0 Turn the function selector to adjust the cooking time until the oven displays “10:00”. 36 3/USING YOUR APPLIANCE Press the or Press the key to cancel the setting. Key to start cooking EN Note: Halfway through the grilling time the oven will beep twice. Combination Cooking Press the Gril key once, the screen display “G-1”. Gril Display G-1 Gril Keep pressing the Gril key until “G-2” or “G-3” displays. Key to start cooking G-2 37 EN 3/USING YOUR APPLIANCE Display Speedy Cooking In waiting state, press the key to start cooking with 100% microwave power for 30 seconds, each added press will increase 30 seconds. [. . . ] M-O In cooking state, press the key to inquire the current time and the time will display for 3 seconds. Lock-out Function for Children Lock: In waiting state, press the key for 3 seconds, there will be a beep denoting entering the children-lock state and the current time will display if the time has been set, otherwise, the oven will display “ “. Affichage key for Lock quitting: In locked state, press the 3 seconds, there will be a long “beep“ denoting that the lock is released. During cooking, if the door is opened and after closing the door, Depart button must be pressed to continue cooking. [. . . ]