User manual BRANDT SPOUTNIK

[. . . ] This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capacities or lack of experience and knowledge. € SAFETY RECOMMENDATIONS Your appliance is designed for standard household use for cooking, reheating and defrosting foods. The manufacturer declines any responsibility in the case of inappropriate use. To avoid damaging your appliance, never operate it while empty or without the turntable. [. . . ] If you see any kind of damage, before doing anything else, contact your retailer. In order to easily locate the reference information for your appliance, we recommend that you note these data on the “After-Sales Service Department and Customer Relations” page. 5 mm2 conductors (1 ph + 1 N + ground) that must be connected to a monophase 220-240 V network via a CEI 60083 standardised receptacle (1 ph + 1 N + ground lead) or in accordance with installation rules. The safety wire (green yellow) is connected and must to the appliance’s terminal be connected to the ground lead of the electrical set-up. In the case of connections with an electric receptacle, it must remain accessible after installation of the appliance. The oven’s neutral conductor (blue wire) must be connected to the network’s neutral conductor. In your electrical installation, allow for a user-accessible device that must be able to separate the appliance from the main power supply and whose contact opening is at least 3 mm above all the terminals. If the power cable is damaged, it should be replaced by the manufacturer, its after-sales service department or by a qualified person to avoid danger. Warning: We cannot be held responsible for any accident resulting from an inexistent, defective or incorrect ground lead. If the oven malfunctions in any way, unplug the appliance or remove the fuse corresponding to the sector there the oven is hooked up. • ELECTRICAL CONNECTION Ensure that: - The electrical installation has sufficient voltage. - The diameter of the wires complies with the installation requirements. - Your electrical installation is equipped with 16-ampere thermal-sensitive protection. The electrical connections are made before the appliance is installed in its housing. During installation and maintenance operations, the appliance must be unplugged from the electrical grid; fuses must be cut off or removed. The oven must be connected with a power cable (standardized) with three - 30 - UTENSILS See the instructions on “Materials you can use in microwave oven or to be avoided in microwave oven. € There may be certain non-metallic utensils that are not safe to use for microwaving. If in doubt, you can test the utensil in question following the procedure below. Fill a microwave-safe container with 1 cup of cold water (250ml) along with the utensil in question. CAUTION Personal Injury Hazard It is hazardous for anyone other than a competent person to carry out any service or repair operation that involves the removal of a cover which gives protection against exposure to microwave energy - 31 - 1. Select a level surface that provide enough open space for the intake and/or outlet vents (no built in). (1) Leave a minimum clearance of 12 inches (30cm) above the oven and 6 inches (15cm) behind the oven. [. . . ] Let the food in stand-by state after defrosting: stand-by time uses to be the same than defrosting time. Defrost meats and fishes on an upside down saucer put on another plate, in order to let the juice leak to avoid a start of cooking. Keep aware to put off all metal links when you defrost food directly on their bags. For bread or pastry (flaky pastry…) defrosting, put it on absorbing paper and turn on when it is halfcooking. [. . . ]