User manual BRITAX AFFINITY 2

[. . . ] The BRITAX AFFINITY 2 is intended for children from 6 months and up to 17 kg or 3 years of age. Suitable from birth with Britax Römer BABY-SAFE infant carriers and BRITAX AFFINITY 2 Carrycot (available separately). This product is not suitable: • For jogging, running, skating or the like. € As a travel system in combination with carriers other than the infant ones mentioned in this user guide. [. . . ] When folding and unfolding the product, always ensure that the brake is engaged all locks are properly engaged. Open the fold lock and pull the pushchair up with each hand holding onto one side of the stroller. Ensure that the chassis is properly installed and that the central hinge has safely locked into place with an audible click noise. When engaging the brake always ensure that you test it by carefully pushing the pushchair with both hands still on the handle bar. Engaging the brake To engage the brake push the rear end (marked with the red strip) of the brake pedal down. Releasing the brake To release the brake push the front end (marked with the green strip) of the brake pedal down. 5 Attaching and removing the seat unit, infant carrier and BRITAX AFFINITY 2 arrycot c with the Click & Go® Adapters 5. For attaching the carrycot and infant carriers, please ensure that you follow their user instructions. The BRITAX AFFINITY 2 uses the innovative Click & Go® attachment system. The BRITAX AFFINITY 2 seat unit, carrycot and Britax Römer infant carriers use the same adapter system to be at- AVERTISSEMENT !How to attach/release To attach, just place the Click & Go® adapters over the chassis sockets and push the seat unit into the socket. Always ensure that your seat unit Click & Go® adapter is fully connected before using the pushchair!To release, use both hands to pull the left and right trigger of the Click & Go® adapter on your seat unit upwards and pull the seat unit away from the chassis. How to attach/release To attach, just place the Click & Go® adapters over the chassis sockets and push the seat unit into the socket. Always ensure that your carrycot Click & Go® adapter is fully connected before using the pushchair!To release, use both hands to pull the left and right trigger of the Click & Go® adapter on your carrycot upwards and pull the carrycot away from the chassis. How to attach/release Please follow the instructions in the user guide of your infant carrier. When adjusting the seat angle, always ensure that the recline locking mechanism has properly locked in before using the pushchair. The angle of the seat can be adjusted with the seat forward or rearward facing on the chassis. 2 Harness height adjustment The harness can be adjusted to two different heights. Always ensure that the correct height for the occupying child is adjusted. To adjust the harness height ensure that the buckle is open and that the waist strap tongue is disconnected from the shoulder strap tongue. [. . . ] To open the harness: • Push the button on the buckle and release waist and shoulder straps from the buckle. 10 Attaching the apron Slide the apron over the footrest as shown in the image. Attach the apron with the popper buttons at the back of the seat unit. Care instructions The seat cover and hood can be cleaned with a sponge and warm soapy water. [. . . ]