User manual BROTHER LOCK 929D

[. . . ] When using the sewing machine, basic safety precautions should always be followed, including the following. Always unplug this sewing machine from the electrical outlet immediately after using and before cleaning. Close attention is necessary when the sewing machine is used by or near children. Use this sewing machine only for its intended use as described in this manual. [. . . ] (2) If you cannot find the correct tension, refer to the illustrations "In this case" on following pages. NOTE: Order of thread tension adjustment When you adjust the thread tension, do it in the following order: (1) Left needle thread (2) Right needle thread (3) Upperlooper thread (4) Lowerlooper thread This is the easiest way to obtain the correct thread tension. (Naranja) NOTE: Order of thread tension adjustment When you adjust the thread tension, do it in the following order: (1) Needle thread (2) Upperlooper thread (3) Lowerlooper thread This is the easiest way to obtain the correct thread tension. (1) Place a piece of scrap material under the presser foot for test sewing. nOTE: Always lift the presser foot before placing the fabric under it. Just running the fabric under the foot without lifting the presser foot may cause an uneven seam. (2) Holding the needle threads with your left hand, turn the pulley slowly a few times in the counter clockwise direction with your right hand, and check to see that the threads entwine themselves before using the foot pedal to sew. After test-sewing, continue to depress the foot If this happens, pull the threads slightly. Check the threading order and adjust the thread tension to create an even chain. Thread the machine and pull the threads out · About 15 cm (6 inches) behind the presser foot. Lift the presser foot and place the material well underneath the presser foot before starting to sew. If the stitch is not uniform, re-check that the threading has been done properly and in sequence. follow the Seam Allowance Guide (3/8 , 1/2 , 5/8 , 1") for consistent cutting of the fabric seams. 1 Presser foot 2 Upper knife When the seam is finished, keep the machine Running at a low speed to obtain chaining-off. replace the material under the presser foot and sew 3-5 cm (1-1/8 to 2 inches) over the previous stitches. CAUTION Do not leave straight pins in the fabric when sewing as they will damage the needles and knives. (1) Adjust the presser foot to prevent the material from puckering and to allow sewing of curves. ) (2) Loosen the thread tension, but remember that if the tension is too loose, the thread may break and stitches may be skipped. (3) Dull knives will not cut a clean seam, and will also cause the fabric to pucker. The cutting knives need to be replaced if you notice the fabric puckering while sewing. The pressure of the presser foot can be adjusted By turning the pressure adjustment screw at the top left of this machine. Since this machine has already been adjusted to a pressure suitable for light to medium fabrics, no further adjustment is necessary except when sewing on very heavy or very light materials. [. . . ] By turning the screw backward (away from you) the stitch guide will go to the left. 1 On Two-needle models 2 Upperlooper 3 Stitch finger 4 Stitch finger release lever 5 Stitch width lever 6 Regular needle plate 7 Stitch length adjustment lever 8 Making lines 9 Fold in two 0 Adjusting screw A Fabric guide Attractive decorative stitches can be made through different combinations of fabric and thread. Decorative thread with a high thread count or extremely fine thread can be used in the upperlooper to produce decorative stitches to make any project more exciting. Other special purpose presser feet that are available (1) Tape presser foot For all models: LT5 Parts No. [. . . ]