User manual BROTHER LX-570

[. . . ] See the reverse for available cartridges and for application ideas on using your LX-570. Your LX-570 comes with a "starter" cartridge already installed, which applies a permanent adhesive backing to an item. Cutter bar Knob Exit area Notes: Before using, remove the protective tape and other packaging materials under the top cover. Under the terms of an agreement with Xyron, Inc. , the purchase or other acquisition of this product confers no right or license to use the product in the Retroreflective Field. Latch (opens top cover) Feed Deck. [. . . ] Then 2 Insertthecartridge: and lower Lift up the latch to open Open top cover grasp the cartridge in one hand, hold the LX-570 with the other, and lift the cartridge up and out. Notes: When placing a partially-used cartridge back in the machine, be sure the material does not adhere to the cartridge itself. When removing a used cartridge whose material has wrapped around the rollers, remove the cartridge and pull the material from the rollers. the cartridge in with the label up, facing the feed deck. As you lower the cartridge, be sure that the backing material fits underneath the cutter bar at the exit area. Close the top cover by gently pushing down until it clicks and is fully seated. Guide the backing material under the cutter bar into the exit area. The cartridge is properly installed when the label is flush with the feed deck. Close the top cover before using. How to Change the Cutter cutter: 1 Unsnap thethumb underneath the back of the Place your place: 2 Snap the new cutter intobar, place the front At any point on the cutter of the cutter into the groove on the cutter bar so the blade fits into it. Avoid touching the blade. 1 cutter knob and your index finger on the cutter bar. Lift up with your thumb to unsnap the cutter from the cutter bar. Back of cutter Groove in cutter bar When installed properly, the cutter slides back and forth on the cutter bar. Blade is at this end and fits into a groove on the cutter bar. Always avoid touching the blade. Warnings & Cautions Warnings: Never place your finger under the cutter bar at the cutter. When handling cutters, take care to avoid injury to yourself or others. Avoid contact of adhesive backing materials with skin or other delicate surfaces. Cautions: All backing materials are permanent once applied and cannot be removed without damage. Once you start feeding an item, do not try to back it out by turning the knob in the opposite direction. Before processing an item, make certain that the cartridge contains sufficient backing material. If uncertain, install a new replacement cartridge to avoid partial processing. [. . . ] It is a good idea to clean whenever you remove and replace a cartridge. To clean the cutter area: Moisten the end of a cotton swab in isopropyl (rubbing) alcohol. Use the moistened end to remove dust, adhesive, or debris from the cutter blade, groove, and exit area. [. . . ]