User manual BROTHER NC-8100H QUICK START

[. . . ] Quick Network Setup Guide Caution: DO NOT touch the surface of the main boards within 15 minutes after turning off the power. For more details about how to optimize the Network board, please refer to the Network User's Guide on the CDROM supplied with the MFC. Two Screws NC-8100h Print/Fax Server Quick Network Setup Guide One Touch Key Sheet (For use with MFC9660, MFC9880, MFC9800 Only) Before Starting Installation: Be careful when handling the NC-8100h. [. . . ] Disconnect any interface cables that are connected to the rear of the machine. Parallel Interface Cable) Unplug the phone lines from the side of the machine. Caution: Make sure the power cord is unplugged before installing or removing the NC-8100h Board. Open the manual feed cover at the rear of the machine. 5. Remove the four screws securing the rear cover and remove the cover. 6. Remove the small cover from rear cover with your hand. 2 7. Remove the two screws securing the metal plate over the main board and remove the cover. 8. Open the scanner cover by pulling the release lever towards you to make it easier to install the NC-8100h. Scanner Cover Release Lever 9. Remove the protective label from the chassis. Protective Label Caution: Always hold the NC-8100h by the edge. Do not touch the surface of the network or main board. 3 10. Plug the NC-8100h into connector P1 located on the main board as shown in the illustration. Make sure that both connectors are firmly together by pushing down the back of the NC-8100h. 11. Refit the metal cover over the main board, inserting it under the flat cable. 13. Refit the two screws into the metal cover. 14. Reconnect the power cable. 4 Step 2: Connecting the NC-8100h to an Unshielded Twisted Pair 10Base-T or 100Base-TX Ethernet Network To connect the NC-8100h to a 10Base-T or 100Base-TX Network, you must have an Unshielded Twist Pair Cable. One side of the cable must be connected to a free port on your Ethernet hub and the other side must be connected to the 10Base-T or 100Base-TX connector (an RJ45 Connector) of the NC-8100h. Verifying Successful hardware Installation: Plug in the AC power cord. After initialization and warm-up (this may take several seconds), the machine will come to a Ready state. Step 3: Installing the BRAdmin Professional: Configuration Utility (For Windows® 9x, NT® 4. 0, Windows® 2000 and XP users only) Note If you have another operating system, refer to the NC-8100h User's Guide located on the CD-ROM with your MFC. From the "Network Application for Optional NC-8100h" menu, select Install Software. From the "For Administrators" menu select BRAdmin Professional. 5 How to refer to the User's Guide The NC-8100h User's Guide can be viewed from the CD-ROM supplied with your MFC in PDF. [. . . ] · No light: This LED will be off when there is no connection to the network and no data is being received. Note If there is a valid connection to the network, the LED will blink orange or green. TEST SWITCH · Short push : Prints a network configuration page. · Long push (more than 5 seconds) : Resets the network configuration back to factory default settings. Ethernet RJ-45 LED Test Switch 6 [. . . ]