User manual BUFFALO WS-QL : TERASTATION™ WINDOWS STORAGE SERVER SETUP MANUAL

[. . . ] You may always shut the TeraStation down before swapping drives if desired. Hot-swapping is only allowed for a failed drive with a ashing red LED. [. . . ] Hot-swapping is only allowed for a failed drive with a ashing red LED. Before removing a good drive, shut down the TeraStation. Error LED Status LEDs 1-4 Replacing a Damaged or Failed Drive Handle the TeraStation carefully. Before removing any drives, touch the metal back of the TeraStation to dissipate any static electricity. Do not replace a failed drive with a drive that has previously been used in another TeraStation or a computer. Steps 1 - 7 are to replace a failed drive while the TeraStation is turned on. Step through the wizard to initialize the drive. Insert the drive with the lock open. Remote Desktop 12 Press the latch until it clicks. 20 Right-click on the new drive and select [Convert to Dynamic Disk]. You may now con gure RAID arrays with this disk. Remote Desktop atch latch 21 13 14 Close the front cover. Start the "RAID Builder" as in steps 1-5. Create a new volume Right click on the dynamic disk and select [New Volume]. To restore a RAID volume (RAID resynchronization) 1 Right-click on the volume labeled "Redundancy Failure", then click on [Restore Volume] from the displayed menu. 2 When "Select the disk from the following list" is displayed, select the new disk and click [OK]. [. . . ] Start the "RAID Builder" as in steps 1-5. Create a new volume Right click on the dynamic disk and select [New Volume]. To restore a RAID volume (RAID resynchronization) 1 Right-click on the volume labeled "Redundancy Failure", then click on [Restore Volume] from the displayed menu. [. . . ]