User manual CANON ES2500 BROCHURE

[. . . ] Holding the printer at other positions is dangerous and poses a risk of injury and damage if the printer is dropped. Be sure to remove the Cassette and Output Tray before installing the printer. Grasp the handle on the front of the Cassette and pull it forward a little. Holding the Cassette on both sides with both hands, remove the Cassette. [. . . ] Holding the Cassette on both sides with both hands, remove the Cassette. Holding the Output Tray on both sides by the far end, press the button to release the lock, and then remove the Tray. If a roll is loaded, be sure to remove the roll before this procedure. Fasten a paper band or the like around the paper to prevent the roll from unwinding. Assembling and Installing the Desktop Basket Assemblage et installation du panier de bureau Assemblaggio e installazione del raccoglitore da scrivania ??????????Put the Basket Table (K) on a desk or other ?at surface and push it against the desk to eliminate any space between the side of the Basket Table (a) and the edge of the desk. 7) in "Assembling the Output Stacker and Installing the Stand". Holding the printer on both sides by the Carrying handles, set it on top of the black parts (b) of the Basket Table (K). Align the printer with the diagonal line (c) on the left side of the black part (b). Be careful to avoid pinching your ?ngers between the Output Stacker and Stand. Tighten the Stand Bolts (U) in the order indicated; ?rst at position ?Use the Allen Wrench (R) to tighten the Table Bolts (G) and secure the Basket Table (K) to the Stand and Table Stay (E). For ST-24, tighten the Table Bolts (G) in the order indicated; ?rst at position ?Rotate the Basket Rods #1 (L) on both sides all the way toward the front ( ?) and then return them to the position at which they lock into place ( ?Insert Basket Wire #1 (S) into the hole on the side of the Basket Cloth (M) without the Velcro Tape. Keeping the Velcro Tape side face-down, insert both basket wires into the holes on both sides of the Basket Table (K). Insert Basket Rod Caps (O) on both ends of Basket Rod #2 (N) until the guide lines (h) are no longer visible. Insert the Basket Rod Caps (O) onto the left and right Basket Rods #1 (L) until the guide lines (i) are no longer visible. With Basket Wire #2 (P) positioned so that the bend faces forward, insert it in the hole of the Basket Table (K) from below. [. . . ] Insert the Basket Rod Caps (O) onto the left and right Basket Rods #1 (L) until the guide lines (i) are no longer visible. With Basket Wire #2 (P) positioned so that the bend faces forward, insert it in the hole of the Basket Table (K) from below. Fold the Basket Band (Q) in two and secure it with the Velcro Tape ( ?Hang the Velcro Tape of the Basket Band (Q) on the Basket Wire #2 (P) ( ? [. . . ]