User manual CAT EYE CS-1000 CYCLO SIMULATOR

[. . . ] It may cause the battery to over heat, resulting in fire or damage of the components. · Securely connect the plug so that the light will not turn off while riding, or the cord will not hinder riding. · Never use the ABS if the cord of the battery charger or the switch unit is damaged, Consult with the shop where this lamp kit was purchased. [. . . ] · Safely and properly dispose of the old battery according to your local regulations when it comes to the end of its useful life. WARNING Lamp Unit ABS-20 ABS-25/30/35 Battery Pack x 2 Bracket (H-32) x 2 Important Note · This lamp kit is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure that they do not play with this appliance. · The battery's nature will affect the light output, High light output will remain just before the battery runs out, After that the output drops suddenly. Take precautions against such a situation and prepare a spare light or spare battery packs. · Long periods of non-use will lower the voltage of the battery and will naturally self discharge. · Overdischarge (leaving the light on after the power is completely gone) shortens the performance life of the battery. · If the lamp body or parts become dirty with mud, etc. , clean with a soft cloth which is moistened with mild soap. Note: If the fuse continues to blow, or if the fuse does not recover, call the appropriate service center for assistance. SPECIFICATIONS 6V Halogen spot bulb + wide bulb (ABS-20: 10W+10W/ABS-25: 15W+10W/ABS30: 20W+10W/ABS-35: 20W+15W) Battery pack: ABS-20: Ni-Cd battery Ni-Cd/6V 1600mAh ABS-25: Ni-MH battery Ni-MH/6V 2200mAh ABS-30/35: Hi Ni-MH battery Hi Ni-MH/6V 3000mAh Battery charger: ABS-20: Ni-cd charger (normal) CHR-1610 ABS-25: Ni-MH charger (normal) CHR-2210 ABS-30: Hi Ni-MH charger (normal) CHR-3010 ABS-35: Hi Ni-MH charger (fast) QCHR-3010 * As for Hi Ni-MH charger, normal charger and fast charger is compatible with each other. Standard charging time: ABS-20, ABS-25, ABS-30: 8-10 hours / ABS-35: 3 hours Temperature range: Charging: 0°C - 30°C Operating: ­15°C - 45°C Recharge/discharge number of times: about 500 times (until the rated capacity drops to 50%) * The specifications and design are subject to change without notice. Bulb: Plug Relay Plug Relay Jack Joint Cord There is a pad inside of the jack socket to prevent the plug from falling off the socket. When this pad is deteriorated and you feel the plug's connection is loose, replace the pad with a new one. Connect the battery packs, joint cord and the switch unit as illustrated. If you are using only one battery pack, connect the relay plug directly to the battery pack. Attention: Secure the cord along the frame with the cord belt, so that it will not hinder riding. Note: Wind the cord round the frame so that it will not hinder riding. [. . . ] Attention: Secure the cord along the frame with the cord belt, so that it will not hinder riding. Note: Wind the cord round the frame so that it will not hinder riding. Securely connect the jacks to the plug. LIMITED WARRANTY 2-Year Warranty: Only for Lamp unit, switch unit, battery pack and charger (excluding bulb and deteriorated battery) If trouble or damage occurs during normal use, the product will be repaired or replaced free of charge. [. . . ]