User manual DANFOSS TP7000

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual DANFOSS TP7000. We hope that this DANFOSS TP7000 user guide will be useful to you.


DANFOSS TP7000 : Download the complete user guide (2804 Ko)

Manual abstract: user guide DANFOSS TP7000

Detailed instructions for use are in the User's Guide.

[. . . ] Turning a programmable room thermostat to a lower setting will result in the room being controlled at a lower temperature, and saves energy. The way to set and use your programmable room thermostat is to find the lowest temperature settings that you are comfortable with at the different times you have chosen, and then leave it alone to do its job. The best way to do this is to set low temperatures first, say 18°C, and then turn them up by one degree each day until you are comfortable with the temperatures. [. . . ] 7 Accepting the preset programmes If you are happy to use the preset programmes on page 6, you don’t need to do anything else. To accept these settings just close the front cover and after 2 minutes the pre-settings will automatically be accepted. The unit is now in RUN mode (colon flashes in display) and the heating will operate according to the preset programmes. 8 Before you change the preset programmes Your installer will have set your unit to operate in either 7-day mode or 5/2 day mode. To tell which mode your unit is set press PROG until Event 1 flashes in the display. This unit is in 7-day mode and you can programme different settings for each day of the week (see page 8-9). This unit is in 5/2 day mode and you can enter one of set of programmes for weekdays and another set for weekends (see page 91). 81 Programming in 7-day mode ES DK NL I GR PL LT (separate programmes for each day of the week) a) Press PROG until Event 1 flashes, then press DAY to move from current day to Day 1. B) Amend the time and temperature as follows: i) Use + and – buttons to alter time (press and hold to change in 10 min increments). 1 ii) CZ iii) HR RO iv) c) When all 6 events are correct, press DAY to programme events for Day 2. 8 TP7000 RANGE (If you wish to repeat the previous day’s programme simply press COPY). D) Repeat steps b and c above to programme (or COPY) events for Days 3, 4, 5, 6 & 7. 82 Programming in 5/2 day mode (one set of programmes for weekdays, another for weekends) Press PROG until Event 1 flashes, then press DAY until display shows Day 1-5. Follow steps b and c on page 8-9 to programme times and temperatures for weekdays. [. . . ] 36 TP7000 RANGE (Hvis du ønsker at gentage den foregående dags program , skal du blot trykke på COPY). D) Gentag trin b og c ovenfor for at programmere (eller kopiere) begivenheder for dag 3, 4, 5, 6 og 7. 82 5/2-dages tilstand (et sæt begivenheder for hverdage og et andet sæt for weekender) D ES Tryk på PROG, til Event 1 blinker, og tryk derefter pås DAY, til displayet viser Day 1-5. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE DANFOSS TP7000




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual DANFOSS TP7000 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.