User manual DE DIETRICH DOP 450

[. . . ] Qxd 06/06/05 10:07 Page 24 Table of Contents Introduction What does your oven look like?Description of the appliance Accessories Safety recommendations How do you install your oven?Electrical connection Changing the power cable Useful dimensions for installing your oven How does your oven work?Close-up of your analogue programmer How do you set the clock on the oven? [. . . ] 2) Drill a Ø 3 mm hole in the cabinet panel to avoid splitting the wood. 4) Replace the rubber screw covers (they also serve to absorb the shock caused by closing the oven door). To be certain that you have properly installed your appliance, do not hesitate to call on a household appliance specialist. Close-up of your programmer 9 2 1 11 3 4 1 2 3 4 5 6 7 8 9 10 11 32 6 10 8 Clock or timer display Cooking mode display 7 5 Shelf support indicator and selected cooking mode indicator Display of various time adjustment programmes (cooking times and end times) Oven temperature display Locked door indicator (during pyrolysis) Rising temperature indicator Timer indicator Pyrolysis indicator Control lock indicator (child safety device) "Low Temperature Cooking" indicator 99633803_ML_A. gB a) When supplied with electricity • The displays flashes 12:00. € Program the time by turning the setting button toward + or - (the speed with which the button is turned varies the speed with which the time changes) Example: 12:30. -> The display stops flashing b) Resetting the clock time Press down the button for a few seconds. The time display flashes, indicating that it is now possible to adjust the time. To set the time, turn the button toward + or - so as to advance or turn back the displayed time. After entering the time of your choice, enter it by pushing the button -> the display stops flashing. The time cannot be set if the oven is in delayed cooking mode In the event of a power outage lasting less than 35 hours, when electricity is restored, a message indicates that your oven will automatically readjust the time displayed. The analogue programmer should display only the time; it should not be flashing. € Press and turn the button toward the right to select the cooking mode. When your cooking programme is finished, a three-beep pattern will be emitted for a few minutes. Your oven is equipped with an electronic timer that is independent of the oven functions, making it possible to measure times. In this case, the timer display takes priority over the time of day display. Turn the button until you obtain the desired length of time (max 59 minutes and 59 seconds) Enter the time by pressing the button. The display stops flashing and the timer starts working, counting down the time in seconds. When the cooking time is finished, the timer starts beeping to alert you and the hourglass begins flashing. It is possible to change or cancel the timer programme at any time by turning it to 0 and pressing the button to enter. * GB The analogue programmer should display only the time; it should not be flashing. € Place your dish in the oven based on the recommendation indicated in the display. [. . . ] Biscuits, vegetables, RELATIVELY CLEAN pastry, quiches, soufflés COOKING APPLICATIONS DIRTY COOKING APPLICATIONS VERY DIRTY COOKING APPLICATIONS Meats, fish, (in a dish) stuffed vegetables Large cuts of meat on the spit Splatter-free cooking pyrolysis is not warranted Pyrolysis is warranted after three cooking cycles pyrolysis can be performed after one cooking application of this kind if there is a lot of splattering You should not wait until the oven is coated in grease to initiate a cleaning cycle. Programming for immediate pyrolysis a) Remove the grids and trays from the oven and clean any major spill residue. B) Ensure that the programmer is displaying the time of day and that it is not flashing c) Press the selector button, then turn the selector button to the left to the position 42 . Qxd 06/06/05 10:07 Page 43 How do you clean the cavity of your oven ? [. . . ]