User manual DOMETIC 9000

[. . . ] used without the safety alert symbol indicates, a potentially hazardous situation which, if not avoided, may result in property damage. Read and follow all safety information and instructions. CAUTION 4. Swing rafter out and towards the roller tube end cap. When opening an awning with Short Universal Hardware, pull on the rafter claw to telescope the two inner channels out of the assembly. The innermost channel must extend out until the spring button pops in the hole on the upper surface of the middle channel. [. . . ] 6 Wrap Pull Strap Around Right Arm Assembly 3 Sunchaser, 8500 & 9000 Awnings User's Guide 1. If light rains are expected, place the awning in the water shed position. 9. 3. Snap the patio foot into the bottom mounting bracket on the coach side wall. 11 Lower Arm Away From Door 7-8 Additional Holes Note: Universal hardware is designed with a water dump feature that will lower one side of the awning to allow water to run off. Before the water dump feature will operate as designed, lower both arms 7 to 8 holes (fabric slope approximately 10 degrees) below the coach awning rail. If using Short Universal Hardware, telescope the innermost channel into the middle channel by proessing down on the spring button and pushing the channel inward. Make sure that the innermost and middle channels will telescope freely into the outermost channel before attempting to roll up the awining. Important: If the 8485000 hardware is used with a tension rafter the water dump feature is disabled. The awning must be placed in the water dump position the same as the 8275000 hardware. Note: Sunchaser Model Series 8275000 hardware is not equipped with the water dump feature and one arm must be an additional 7-8 holes (fabric slope approximately 10 degrees) lower than the other arm before it is in the water dump configuration See FIG. Note: Never leave an open awning unattended. CAUTION ON Universal models: Be sure to follow the instructions inside the of the hardware regarding proper stowing. Attempting to stow the rafter on the foot at the base of the water dump device could damage the hardware. 5. For Sunchaser models, swing rafters back against side wall resting on top of the patio foot in the arm assembly. For Universal models do the same thing on the side without the water dump feature. However, on the water dump feature install the end of the rafter on the pin at the top of the gas spring. Grasp pull strap in left hand and move towards the center of the roller tube. 12. B. 1. TO CLOSE AWNING When in the carport position, remove stakes from the ground and unwrap pull strap. Grasp the upper arm with both hands, and raise lift handle to release lock button. 10 Raise Handle To Release Lock Button, Lower To Shortest Position Important: Do Not release pull strap. Awning is under spring tension and it could roll up unexpectedly and quickly against the vehicle side. 2. Make sure the lock lever on the awning right hand torsion is in the roll down position. !WARNING Pinch hazard: Always check to ensure the lock lever is in the roll down position. Failure to place Lock Lever in the roll down position will allow the awning to roll up unexpectedly and quickly resulting in pinching of hand, arm and/or damage to awning. 4 FIG. [. . . ] Rolling up of the awning will apply the mixture to the underside of the fabric. In addition to its beauty and soft translucence, woven acrylic fabric offers the advantages of strength and breathable. It is water repellent; but because it is a woven cloth, it is not water proof. To keep your acrylic awning clean, simply hose it off occasionally and let it dry. [. . . ]