User manual DOMETIC ANALOG CONTROL KIT

[. . . ] When you see this symbol in this manual, be alert to the potential for personal injury. Follow recommended precautions and safe operating instructions. For a more permanent solution to a high heat gain, accessories like A&E outdoor patio and window awnings will reduce heat gain by removing the direct exposure to the sun. They also add a nice area to enjoy company during the cool of the evening. Condensation Note: The manufacturer of this air conditioner will not be responsible for damage caused by condensed moisture on ceilings or other surfaces. [. . . ] This equipment must be serviced by qualified personnel and some states require these people to be licensed. 3. Place the Temperature Set Lever to desired temperature level (located at right side of thermostat). Select fan speed that best satisfies your needs: (switch located at lower center of thermostat). High Speed: Selected when maximum cooling and dehumidification are required. Low Speed: Selected when RV reaches desired comfort level and needs to be maintained. Select Auto/On Switch operation as follows: (switch located at upper center of thermostat) a. Auto Position: Air conditioner fan runs whenever cooling is required and stops whenever cooling is not required. On Position: Air conditioner fan runs continuously to circulate air in RV. B. Set the Temperature Set Lever to desired temperature level (located at right of thermostat). Set the System switch to furnace position (located at left side of thermostat). The furnace will now come on when heat is required and cycle off when temperature level selected is reached. 3. 4. Set the System Switch to cool position (located at left side of thermostat). The air conditioner compressor will now come on when cooling is required and cycle off when the temperature level selected is reached. C. Auto/On Switch: is in the ON position, the air conditioner fan will run continuously at selected fan speed to circulate the air inside the RV. Set the Temperature Set Lever (located at right of thermostat) to desired temperature level. Set the System Switch (located at left side of thermostat) to heat strip position. Wait at least two (2) minutes before restarting the air conditioner after shutting off with either the Heat/Off/Cooling Switch or the Temperature Set Lever. This allows the refrigerant pressure in the air conditioner to equalize and will allow the compressor to restart easily. Failure to follow this instruction may cause circuit breakers or fuses to open. 3 E. [. . . ] Close register on your quick cool return air cover fully or partially, depending upon your personal preference. Turn your A/C controls to setting you desire in the normal manner. 5. SERVICE - Unit Does Not Operate If your unit fails to operate or operates improperly, check the following before calling your service center. If your RV is connected to motor generator, check to be sure motor generator is running and producing power. [. . . ]