User manual DOMETIC BRISK AIR AC INSTALLATION

[. . . ] INSTALLATION INSTRUCTIONS RECORD THIS UNIT INFORMATION FOR FUTURE REFERENCE: Model Number Serial Number Date Purchased BRISK AIR 579 Series, 590 Series, & 595 Series USA SERVICE OFFICE Dometic Corporation 2320 Industrial Parkway Elkhart, IN 4656 574-294-25 CANADA Dometic Corporation 46 Zatonski, Unit 3 Brantford, ON N3T 5L8 CANADA 59-720-9578 For Service Center Assistance Call: 800-544-488 ® ROOF TOP AIR CONDITIONER USED WITH 3107210 AIR DISTRIBUTION BOX KIT and 3109226. 005 COMFORT CONTROL CENTER ELECTRONIC KIT 3109228. 001 (White) Comfort Control CenterTM 3109228. 019 (Black) Comfort Control CenterTM This manual must be read and understood before installation, adjustment, service, or maintenance is performed. Modification of this product can be extremely hazardous and could result in personal injury or property damage. Lire et comprendre ce manuel avant de procéder à l'installation, à des réglages, de l'entretien ou des réparations. L'installation de cet appareil doit être effectuée par un réparateur qualifié. Toute modification de cet appareil peut être extrêmement dangereuse et entraîner des blessures ou dommages matériels. INSTALLATION INSTRUCTIONS 3109395. 066 REVISION: Form No. [. . . ] In a multiple zone installation, this wiring is required in only one of the 14-1/4" (±1/8") openings. If a Remote Temperature Sensor is used, the connector end must be routed to the roof opening of the system which it will control. Make sure that at least 5" of the sensor cable extends into the roof opening. Refer to the Remote Sensor Instructions for details of the installation. If the system is to be used WITHOUT a Remote Temperature Sensor, the proper location of the Comfort Control CenterTM is very important to ensure that it will provide a comfortable RV temperature. Install the Comfort Control CenterTM on a partition, not on an outside wall. NEVER expose it to direct heat from lamps, sun or other heat producing items. Avoid locations close to doors that lead outside, windows or adjoining outside walls. If the system is to be used WITH a Remote Temperature Sensor in ALL zones, the Comfort Control Center may be mounted anywhere that is convenient in the coach. Refer to the instructions provided with the Remove Temperature Sensor for details of installation. 6 INSTALLATION INSTRUCTIONS 3. A 3/8" diameter hole will be needed to route the cable through the wall. CONTROL CABLE INSTALLATION A 4-conductor control cable must be routed from the roof opening to the Comfort Control CenterTM. Choose the shortest, most direct route from the 4/4" (±/8") opening to the Comfort Control CenterTM location selected. Thecontrolcablethatshouldbeusedisaflat, 4- conductor telephone cable. The control cable must be terminated with two (2) RJ-4C-6P telephone connectors. To prevent back injury, use a mechanical hoist to place Air Conditioner on roof. C. Lift and place the unit over the prepared opening using the gasket on unit as a guide. This may be accomplished by inserting a small screwdriver under the tab on the bottom edge of the front cover and gently prying. This may damage the neoprene gasket attached to the bottom and create a leaky installation. D. Both kits contain mounting hardware for the air conditioner and will be used inside the RV. Insert the control cable through the hole in the base plate and mount the plate to the wall with the two screws provided. Install the control cable RJ--4C-6P connector into the back of the Comfort Control CenterTM and gently 7 INSTALLATION INSTRUCTIONS 6. [. . . ] Check fan speeds, cooling mode, furnace (if connected) and heat strip. If the features do not work, check all wiring andconfirmthatthecorrectoptionshavebeenselected on the Electronic Control Box. See Comfort Control CenterTM Operating Instructions. Disconnect 120 volt AC. Failure to follow these instructions could create a shock hazard causing death or severe personal injury. [. . . ]