User manual DOMETIC LA-03

[. . . ] If the "EXTEND" or "RETRACT" button is momentarily pressed during the automatic mode, the control will stop the movement. TO MANUALLY OPEN OR CLOSE AWNING: Note: The awning is designed to be manually operated in emergencies or power outages by the use of a hand crank supplied with the awning. Insert hand crank in the hole on the right (motor) end of the awning and through the stirrup inside. Extend awning until lateral arm has 1/4 to 3/8 inch space at the elbow joint. [. . . ] The Wind sensor switch is located on the face of the control box. "ON" position one of the above situations has occured: (1)the wind sensor feature is not functioning. Solution: Turn the sensor switch to the "OFF" position and wait until the ambient temperature is above 30 degrees F. If alarm is still sounding contact a Dometic Service Center or a qualified service technician for assistance. with sensor turned to "ON". Key Fob CAUTION Remote Switch CAUTION The A & E Lateral Arm awning is extremely durable and can be operated during moderate rain and wind conditions. However, when periods of heavy rain and/or wind is expected the awning should be closed. Damage caused by wind and rain is not covered by warranty. Black Retract Button When the wind sensor is set to "ON" position DO NOT hang items from the awing or tie the awning down. Damage to the awning and items may occur if the sensor is activated and the awning attempts to roll in. The Lateral Arm Awning Control monitors the wind sensor switch position and wind speed events over the preset wind speed and stores it in memory. RETRACT IGNITION LOCK FEATURE Whenever the vehicle ignition is on, a signal is sent to the awning controls to prevent the canopy from extending and AC power is available. CAUTION Note: The control box system is protected with a 5 amp resetable fuse. If needed, reset the fuse by depressing the button on the face of the control box labeled "Reset Circuit". When the wind sensor is set to the "OFF" position, and the wind speed exceeds the control preset level, damages may occur. Damage caused by wind is not covered by warranty. If Awning will not operate and wind sensor switch is in the "ON" position, wind conditions may be above the preset wind speed which will not allow the awning to open. If wind sensor is `ON" and the sensor cable becomes unplugged with the awning in the out position, it will automatically close in 30 seconds. The wind sensor is specifically designed to allow air to pass through the carousel. If the sensing element in the wind sensor becomes wet the awning will not open if closed; or will automatically close if open. Normally the only way for it to get wet is by driving in rain or spraying water directly into the carousel. However, it is possible for it to get wet from severe angled rains or water condensing on the wind sensor. If you suspect this has occurred wait ten minutes for it to dry out before operating awning. [. . . ] Liberally slosh the mixture on the top of the fabric and roll the awning in for 5 minutes. Note: Operating the awning in and out more than two times in secession can cause the motor overload to open. Always make sure that the awning is fully extended or closed before opening the door. [. . . ]