User manual DOMETIC RM1350

[. . . ] 4. Immediatelycallyourgassupplier. USER manUal REfRigERatoR foR lP-gaS & ElEctRic oPERation POURvOTRESéCURITé Sivoussentezuneodeurdegaz: 1. Ouvrezlesfenêtres. 4. Avertissezimmédiatementvotre fournisseurdegaz. FORYOURSAFETY Donotstoreorusegasolineorother flammable vapors and liquids in the vicinityofthisoranyotherappliance. POURvOTRESéCURITé Nepasentreposerniutiliserdel'essence ni d'autres vapeurs ou liquides inflammables à proximité de cet appareil ou de tout autreappareil. !WARNING Improperinstallation, adjustment, alteration, serviceormaintenancecancause injuryorpropertydamage. Refertothis manual. Forassistanceoradditionalinformation consult a qualified installer, serviceagencyorthegassupplier. Une installation, un réglage, une modification, uneréparationouunentretiennon conformeauxnormespeutentraînerdes blessures ou des dommages matériels. Pour obtenir de l'aideoudesrenseignementssupplémentaires, consultezuninstallateurouun service d'entretien qualifié ou le fournisseurdegaz. ! [. . . ] Cleaning the refrigerator is usually done after it is defrosted or put into storage. use lukewarm weak soda solution to clean the interior liner of the refrigerator. use warm water only to clean the finned evaporator, gasket, ice tray and shelves. dEfRoSting 1. shut off the refrigerator by pressing the main power ON/OFF button (OFF position). Leave the cabinet and freezer doors open and place the drip tray under the finned evaporator. Defrosting time can be reduced by filling the ice trays with hot water and placing them in the freezer compartment. CAUTION Never use strong chemicals or abrasives to clean these parts, as the protective surfaces will be damaged. Do not spray liquids near electrical outlets, connections or the refrigerator components. To keep the refrigerator operating efficiently and safely, periodic inspection and cleaning of several components once or twice a year is recommended: · Check the lower vent, upper vent and area between these openings for any obstructions such as bird/insect nests, spider webs, etc. · Make sure the refrigerator area is free from combustible material, gasoline and other flammable vapors or liquids. In order to keep the refrigerator working properly it is important that service is performed on a regular schedule. at least once a year, a qualified service technician should inspect the connections, the control system, the LP gas pressure and flue baffle. CAUTION Do not use: · A knife or an ice pick, or other sharp tools to remove frost from the freezer shelves. Permanent damage could result from warping the metal or plastic parts. 4. Replace the food and set the thermostat to the coldest setting for a few hours. Then, reset the thermostat to the desired setting, usually at mid setting. maintEnancE & SERVicE CAUTION If your refrigerator stops cooling, immediately turn the refrigerator off and see a Dometic dealer. StoRagE PRocEdURE / WintERizing thE REfRigERatoR Rm1350im, Rm1350mim & Rm1350Wim The refrigerator is equipped with a heater tape wrapped around the water solenoid valve and outlet water tube. During cold weather operation below 32°F/0°C the automatic temperature switch will turn the heater tape on automatically. If the RV is in storage and the refrigerator or the DC power is turned OFF there will be no 12V DC present to operate the heat tape; therefore, it will be necessary to drain and dry the ice maker and the water dispenser (if applicable). This will prevent water from freezing in the solenoid valve or becoming stale and producing bad tasting ice. If the temperatures are expected to reach or exceed 0°F/-18°C the ice maker and water dispenser (if applicable) must be drained to prevent component damage and leaks. For instructions, see the following sections DRaINING ThE ICE MakER and DRaINING ThE waTER DIsPENsER. - 1 - maintEnancE & SERVicE dRaining thE icE makER Draining of the ice maker must be performed by qualified service personnel only. Remove inlet fitting to ice maker water solenoid valve. WATER SOLENOID VALVE - RM1350IM 4. Remove the plastic nut and water line from outlet side of the water solenoid valve. Connect compressed air onto the inlet fitting of the water solenoid valve. apply aC power to the solenoid valve by forcing the ice maker mold assembly through several harvest cycles. [. . . ] The seller does not authorize any person or company to create any warranty obligations or liability on their behalf. This warranty is not extended by the length of time which you are deprived of the use of the product. Repairs and replacement parts provided under the terms of this warranty shall carry only the non-expired portion of this warranty. In no event shall either seller be liable for incidental or consequential damages. [. . . ]