User manual DOMETIC RM2351 INSTALLATION INSTRUCTIONS

[. . . ] ® INSTALLATION AND OPERATING INSTRUCTIONS REFRIGERATOR FOR LP-GAS AND ELECTRIC OPERATION RM2351 Contents: Installation Operating Instructions Maintenance & Service Page 4 8 12 FOR YOUR SAFETY If you smell gas: 1. FOR YOUR SAFETY Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. WARNING: Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. For assistance or additional information consult a qualified installer, service agency or the gas supplier. Pour votre sécurité Si vous sentez une odeur de gaz: 1. [. . . ] FOR YOUR SAFETY, when refueling, shut off all LP gas appliances which are vented to the outside. Refrigerator control panel A B ON AUTO CHECK 1 OFF 2 GAS AUTOMATIC REFRIGERATOR TEMPERATURE CONTROL START UP INSTRUCTIONS A. A continuous 12 volt DC supply must be available for the electronic control to function. In AUTO mode operation, the temperature is controlled by a factory preset temperature setting, on the energy source selected by the control system. In GAS mode operation, the temperature is controlled by a factory preset temperature setting. GAS MODE 1. Within 45 seconds the burner should be ignited and operating normally. If the CHECK indicator lamp (B) illuminates, the control has failed to ignite the burner on GAS. To reset when the CHECK indicator lamp (B) is illuminated, press the main power ON/OFF button (1) to the OFF then ON position. On the initial refrigerator start-up on gas, it may take longer than 45 seconds to allow air to be purged from the gas line. If the refrigerator has not been used for a long time or the LP tanks have been refilled, air may be trapped in the supply lines. To purge the air from the lines may require resetting the main power ON/OFF button (1) three or four times. If repeated attempts fail to start the LP gas operation, check to make sure that the LP gas supply tanks are not empty and all manual shutoff valves in the lines are open. If the problem is still not corrected, contact a service center for assistance. NOTE: Do not continue to reset GAS operation if the CHECK indicator lamp continues to be illuminated after several tries. In GAS mode operation, the temperature is controlled by a factory preset temperature setting. AUTO MODE 1. If 120 volts AC is available, the control system will select AC operation. If 120 volts AC is not available, the control system will automatically switch to GAS operation. Within 45 seconds the burner should be ignited and operating normally. If the CHECK indicator lamp (B) illuminates, the control has failed to ignite the burner on GAS. To reset when the CHECK indicator lamp (B) is illuminated, press the main power ON/OFF button (1) to the OFF then ON position. On the initial refrigerator start-up on gas (120 volts AC is not available), it may take longer than 45 seconds to allow air to be purged from the gas line. If the refrigerator has not been used for a long time or the LP tanks have just been refilled, air may be trapped in the supply lines. To purge the air from the lines may require resetting the main power ON/OFF button (1) three or four times. [. . . ] WARNING DO NOT use a flame to check for gas leaks. GAS EQUIPMENT ASSEMBLY SOLENOID VALVE . Check the control system by connecting/disconnecting 120 volt AC power, start/stop the engine, etc. Compare the operation with the operation described in section Operating Instructions. The LP gas pressure should be checked and the main regulator readjusted if pressure is incorrect. [. . . ]