User manual DSC PC1555MX V2.3

[. . . ] WARNING This manual contains information on limitations regarding product use and function and information on the limitations as to liability of the manufacturer. The entire manual should be carefully read. Instruction Manual PC1555/PC1555MX Software Version 2. 3 LIMITED WARRANTY Digital Security Controls Ltd. warrants the original purchaser that for a period of twelve months from the date of purchase, the product shall be free of defects in materials and workmanship under normal use. shall, at its option, repair or replace any defective product upon return of the product to its factory, at no charge for labour and materials. [. . . ] Press [#] to return to the Ready state. To bypass zones from an LCD keypad: To bypass a zone, the system must be in the Ready state. The display will read. . . Enter Code to Arm System Press the [] key to enter the function menu. The display will read. . . Press (*) for <> Press the [] key to enter the zone bypassing mode. Zone Bypass Zone Search "Zone Name" Zone Search "Zone Name" Zone Search "Zone Name" <> Use the arrow (< >) keys to find the zone to be bypassed and press the [] key to select it. The display will read. . . <> "B" will appear on the display to show that the zone is bypassed. To unbypass a B zone, enter the zone number; the "B" will disappear from the display to show that the zone is no longer bypassed. <> This display will be shown if a zone was open when you entered the bypassing O command. If you bypass the open zone, a "B" will replace the "O". To exit the bypassing mode and return to the Ready state, press the [#] key. Viewing Trouble Conditions The control panel continuously monitors a number of possible trouble conditions. If one of these trouble conditions occur, the keypad will beep twice every 10 seconds until you press any key on the keypad. NOTE: A TROUBLE condition reduces the security your system is designed to provide. Call your installing company for service. 11 To view troubles from an LED or Fixed Message LCD5501Z keypad: A trouble will be indicated by the Trouble light/message, which will remain ON until the trouble condition is cleared. If you cannot determine the cause of the trouble condition, contact your installer for assistance. One or more zone indicators will turn ON, indicating the various trouble conditions: ZONE iNDICATOR TYPE OF TROUBLE 1 . . . . . . . . . . . . . . . . . When this trouble occurs, the Trouble light will turn ON but keypad buzzer will not sound. Press [5], the zone indicator(s) corresponding to the faulted zones will turn ON. Press [6] and the zone indicator(s) corresponding to the tampered zones will turn ON. This trouble is generated when a wireless device exhibits a low battery condition. Press [7] one, two, or three times to view which devices are experiencing battery failure. The following will occur: Keypad displays: Zones with low batteries (LED/Fixed Message LCD keypad zone indicators 1 to 32) Press [7] again 2 Handheld keypads with low batteries (LED/Fixed Message LCD keypad - zone indicators 1 to 4) Press [7] again 3 Wireless keys with low batteries (LED keypad - zone indicators 1 to 8). To view the battery conditions of wireless keys 9 through 16, you must be at an LCD keypad. To set the system time, follow the instructions in "Setting System Date and Time" on page 12. Press [7] Keypad beeps: 1 To view troubles from an LCD Keypad: From the Ready state, use the arrow (< >) keys to scroll to the following message. System Trouble (*2) to View <> View Trouble <> Use the arrow (< >) keys to view which troubles are present on the system. [. . . ] Every installation should be evaluated by a security professional to ensure that all access points and areas are covered. Locks and latches on windows and doors must be secure and operate as intended. Windows, doors, walls, ceilings and other building materials must be of sufficient strength and construction to provide the level of protection expected. A reevaluation must be done during and after any construction activity. [. . . ]