User manual DYSON DC33C ALLERGY PARQUET

[. . . ] Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes. Keep hair, loose clothing, fingers, and all parts of the body away from openings and moving parts, such as the brush bar. Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce airflow. Always extend the cable to the red line but do not stretch or tug the cable. [. . . ] € • • • Check and wash the filter regularly according to instructions to maintain performance. Switch ‘OFF’ and unplug before checking or removing the filter. Hold under a tap and run water through the open end until the water runs clear. Squeeze and twist with both hands to make sure the excess water is removed. Squeeze and twist with both hands to make sure the excess water is removed. Do not put the filter in a dishwasher, washing machine, tumble dryer, oven, microwave or near a naked flame. IMPORTANT: After washing please leave at least 24 hours to dry completely before refitting. bLOCKAGES – THERMAL CUT-OUT This appliance is fitted with an automatically resetting thermal cut-out. If any part becomes blocked the appliance may overheat and automatically cut-out. If this happens, follow the instructions below in 'Looking for blockages'. LOOKING AFTER YOUR DYSON APPLIANCE • • • • • Do not carry out any maintenance or repair work other than that shown in this Dyson Operating Manual, or advised by the Dyson Helpline. Emptying the clear bin • • • • • • • • • • Empty as soon as the dirt reaches the level of the MAX mark – do not overfill. To remove the cyclone and clear bin unit, push the release button to the side of the carrying handle, as shown. To minimise dust/allergen contact when emptying, encase the clear bin tightly in a plastic bag and empty. Place the clear bin and cyclone unit into position on the front of the main body of the appliance. The recess in the base of the clear bin must fit onto the lug on the support bracket. Push the carrying handle down so it clicks into place on the top of the clear bin and cyclone unit. Cleaning the clear bin • • Remove cyclone and clear bin (see 'Emptying the clear bin'). Do not use detergents, polishes or air fresheners to clean the clear bin. Do not immerse the whole cyclone in water or pour water into the cyclones. Clean the cyclone shroud with a cloth or dry brush to remove lint and dust. To replace, first close the clear bin base so it clicks into place and is secure. [. . . ] € • 14 15 the appliance is used in the country in which it was sold or (ii), if the appliance is used in Austria, Belgium, France, Germany, Ireland, Italy, Netherlands, Spain or the United Kingdom and the same model as this appliance is sold at the same voltage rating in the relevant country. € • WHAT IS NOT COVERED • • • • • • • • • • Dyson does not guarantee the repair or replacement of a product where a defect is the result of: Accidental damage, faults caused by negligent use or care, misuse, neglect, careless operation or handling of the appliance which is not in accordance with the Dyson Operating Manual. Use of the appliance for anything other than normal domestic household purposes. Use of parts not assembled or installed in accordance with the instructions of Dyson. [. . . ]