User manual EPSON EMP-TW100

[. . . ] The documentation for your EPSON projector is divided into the following four manuals. Unpacking and Installation Guide This manual contains information on the procedures from unpacking the projector through to starting to use the projector, and also describes the included accessories. Safety Instructions/ World-Wide Warranty Terms This manual contains information on using the projector safely, and also includes safety instructions , worldwide warranty terms and a troubleshooting check sheet. Setup Guide This manual describes the preparations required in order to start using the projector (such as remote control preparation and connecting video equipment or a computer). [. . . ] If you are having a problem with the projector, first check the projector's indicators. The following tables show what the indicators mean and how to remedy problems that they indicate. Problem and remedy Stop using the projector, disconnect the power cord from the electrical outlet, and contact your dealer or the nearest address provided at "International Warranty Conditions" in Safety Instructions/ World-Wide Warranty Terms included in the package. Fan problem/ Stop using the projector, disconnect the power cord from the Sensor problem electrical outlet, and contact your dealer or the nearest address provided at "International Warranty Conditions" in Safety Instructions/ World-Wide Warranty Terms included in the package. When replacing the lamp, check that the lamp and the lamp cover are securely installed. If the lamp or lamp cover is not securely installed, the projector power will not turn on. If the lamp is broken replace by a new lamp, or contact your local dealer for further advise. If replacing the lamp yourself, be careful to avoid pieces of broken glass. Lamp operating This can happen when the main power switch at the rear of the p. 48 error projector was turned off before the cool-down period had finished the last time the projector was turned off, and it was then turned back on again before one hour had passed. When the cooling fan stops, turn off the main power switch and then turn it back on again. When the main power switch is turned back on, the projector will return to its previous state, so press the [Power] button on either the projector's control panel or the remote control to turn it back on. If the lamp operating error happens again when the power is turned back on, remove the lamp and check if the lamp is broken. Then turn on the main power switch at the rear of the projector and press the [Power] button on either the remote control or the projector's control panel. If the indicators still show a problem, stop using the projector, turn off the main power switch, disconnect the power cord from the electrical outlet, and contact your dealer or the nearest address provided at "International Warranty Conditions" in Safety Instructions/ World-Wide Warranty Terms included in the package. 46 When the cooling fan stops, turn off the main power switch at the rear of the projector and then check the following two points and take any steps that are required. Check that the air inlet and air outlet are clear, and that the projector is not positioned against a wall. When the main power switch is turned back on, the projector will return to its previous state. Press the [Power] button on either the projector's control panel or the remote control to turn the power back on. If the projector continues to overheat even after the above points have been checked, or if the indicators show a problem when the power is turned back on, stop using the projector, turn off the main power switch, disconnect the power cord from the electrical outlet, and contact your dealer or the nearest address provided at "International Warranty Conditions" in Safety Instructions/ World-Wide Warranty Terms included in the package. (This is not an abnormality, but if the temperature rises too high again, projection will stop automatically. ) · Set the projector up in a place which is well-ventilated, and so Setup Guide that the air inlet and exhaust vents are clear. [. . . ] A type of image signal with a resolution of 640 (horizontal) x 480 (vertical) dots which is used by IBM PC/ AT-compatible computers. A type of image signal with a resolution of 1, 024 (horizontal) x 768 (vertical) dots which is used by IBM PC/ AT-compatible computers. The carrier signal which is contained in the color bar signal used in modern TV transmissions. The carrier signal which is contained in the color bar signal used in high-definition TV (HDTV) transmissions. [. . . ]