User manual EPSON GT-15000

[. . . ] EPSON GT-15000 ® User's Guide Copyright Notice All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SEIKO EPSON CORPORATION. The information contained herein is designed only for use with this EPSON scanner. EPSON is not responsible for any use of this information as applied to other scanners. [. . . ] Insert your document face up in the feeder, bottom edge first, until it meets resistance. Note: Don't push the document into the feed path or the pages may jam. 3. Follow these guidelines to use EPSON Scan: Select the Office Mode in the Mode box. If you want to scan only part of the document page, load the first page only. Adjust the marquee in the Preview area, then load your entire document. When you click Scan, the scanner scans the area defined by the marquee on each page. Note: You can still load documents manually, if you want. Just lift the automatic document feeder and place your document face down on the document table. If you open it while scanning, you'll get an error. 42 Using Optional Equipment Fixing Document Jams If a document gets jammed in the feeder, follow these steps to clear it: 1. Be careful not to tear the paper. Left jam Right jam If a page tears, open the middle cover and remove it as shown: 3. After removing the jammed pages, close the covers and lower the feeder. Make sure the red Error light is off and the green Ready light isn't flashing before trying to scan. If the error isn't cleared, turn your scanner off and then on again. Don't restart EPSON Scan until the green Ready light stops flashing. Note: If you attempt to preview or scan before the scanner is ready, EPSON Scan may stop responding. If this happens, restart your computer. Using Optional Equipment 43 Installing the IEEE 1394 FireWire Scanner Interface Card The IEEE 1394 FireWire scanner interface card (B808342) offers high-speed image transfer and flexible connectivity for your scanner. It supports a peak data transfer rate of 400 Mbps, and allows you to connect multiple IEEE 1394 devices. The card and included cable are shown on the right: To use the IEEE 1394 FireWire interface card, your system must have the following: Built-in IEEE 1394 FireWire port or IEEE 1394 FireWire PCI card (OHCI-compliant) Pre-installed version of Windows XP, 2000 Professional, or Me Follow the steps below to install the IEEE 1394 FireWire card in your scanner and connect it to your computer. Turn off the scanner and disconnect the power cord and any cables. Caution: Static electricity can damage electronic components like the IEEE 1394 FireWire scanner interface card. To discharge static electricity, touch the scanner's metal frame before handling the card. 2. Remove the two screws securing the shield plate to the scanner's optional interface slot. Put the screws and shield plate in a safe place in case you want to reinstall the shield plate later. 44 Using Optional Equipment 3. Turn the card over so that the component side is facing down, and insert it in the optional interface slot. Tighten the retaining screws and reconnect the scanner's cables. 6. Plug one end of the IEEE 1394 cable into the IEEE 1394 port on the card, and the other end into an IEEE 1394 (FireWire) port on your computer. Using Optional Equipment 45 Installing the Network Image Express Card The Network Image Express card (B808392) allows you to share your scanner without the need for a server. [. . . ] For warranty service, you must provide proof of the date of original purchase. What EPSON Will Do To Correct Problems: Should your EPSON product prove defective during the warranty period, please bring the product securely packaged in its original container or an equivalent to your EPSON Dealer or EPSON Customer Care Center. You are responsible for all costs (shipping, insurance, travel time) in getting the product to the service location. EPSON will, at its option, repair or replace on an exchange basis the defective unit, without charge for parts or labor. [. . . ]