User manual EWT CADIZ

[. . . ] This could lead to functional faults, possibly to the ignition of the object. If the mains lead is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. Note that due care and consideration must be taken when using this heater in series with a thermal control, a program controller, a timer or any other device that switches on the heat automatically, since a fire risk exists when the heater is accidentally covered or displaced. Operation Important – Objects or clothing must not be placed on this heater. [. . . ] manual Operation Pressing ‘ ’ from the default HIGH screen (Fig. 8) brings the heater into AUTO mode - see ‘Setting the Timer Programs’. Press again for left hand side heat ( appears on LCD display - see Fig. Press again brings the user full circle to FULL heat mode ( appears on LCD display). Setting the Desired Temperature The desired temperature can be set using the ‘ ’ or ‘ ’ keys. The temperature can be set from 5oC to 35oC and this will be shown on the display. When the temperature is reached the heater will automatically switch OFF. If the ambient temperature drops the heater will come on again automatically. Note the electronic climate control device conserves energy and assists with temperature regulation e. If the heater is set to HIGH heat and the temperature is set to 28oC, at 27oC the heater will switch to a lower heat setting. -4- Setting the Timer Programs Two program settings are possible, P1 and P2. Press ‘ ’ twice, P1 AUTO ON and a time will flash - see Fig. At this point either : (a) press ‘ ’ to exit the Program mode and return to AUTO mode. the heater will s w i t c h O N a n d OFF depending on programme P1 previously entered. OR (b) press ENTER to set the ON and OFF times for program 2, as in steps 1 to 3 above. the heater will switch ON and OFF depending on programme P1 & P2 previously entered. If after programming and returning to the AUTO mode display, P1 or P2 is active, the display will show PROG 1 AUTO ON or PROG 2 AUTO ON depending on which is active - see Fig. An OFF time cannot be entered which is less than the corresponding ON time. When setting the timer programs if no keys are pressed, the display will (after 4 minutes) revert to the previous display i. Storage If the radiator is not required for long periods, for example during the summer, it should be stored in a dry place and preferably covered to prevent the accumulation of dirt and dust. The plug and cord can be stored in the storage area provided – see Fig. The cord should be neatly coiled around the hooks provided and the plug inserted into the pin-hole in the central compartment. [. . . ] The remote allows the set temperature to be adjusted, the mode to be selected or can be used to put the heater in FROST Protection mode. Full Heat output can only be achieved when using the remote control i. Press the ‘ ’ button on the Remote Control to go from OFF, Man On High and back to OFF again. Press the ‘ ’ or ‘ ’ buttons on the remote to set desired temperature between 5oC and 35oC. [. . . ]