User manual FALMEC ATLAS INSTALLATION SHEET

[. . . ] Always check that all the electrical parts (lights, exhaust device), are off when the appliance is not being used. Read the entire instruction booklet before performing any operations on the range hood. The range hood must only be used for the exhaust of cooking fumes in home kitchens. The manufacturer disclaims all liability for any other use of the appliance. [. . . ] Some types of appliance are supplied with a cable without plug; in this case, "standardised" plugs must be used, keeping in mind that: - the yellow-green wire must be used for the earth, - the blue wire must be used for the neutral, - the brown wire must be used for the phase; the cable must not come into contact with hot parts (over 75°C). - fit a plug that is suitable for the load to the power cable, and connect it to a suitable power outlet. For appliances that come supplied with cable and plug please ensure they are plugged into a circuit suitable for this appliance. The manufacturer declines all liability if the safety standards are not observed. In this version, the fumes and steam from the kitchen are conveyed outside through an exhaust duct. The exhaust conveyor that protrudes from the upper part of the range hood must be connected to a duct that carries the fumes and steam outside. In this version, the charcoal filters, if fitted, should be removed; to do this, see the instructions in point F There must be adequate ventilation of the room when the . Range hood is used at the same time as appliances burning gas or other fuels, according to the standard. Deviation for Germany: When the range hood and appliances supplied with energy other than electricity are simultaneously in operation, the negative pressure in the room must not exceed 4 Pa (4x10 E-5 bar). In this version, the air passes through charcoal filters for purification, and is then recirculated back into the kitchen. Check that the charcoal filters are fitted to the motor, and if not, install them as described in the instructions in point H. Light bulbs with different shapes and power ratings from the original may seriously damage the light compartment. To replace the lamp for "Round halogen light": a) Make sure the appliance is disconnected from the mains power supply. B) Remove, by levering with a screwdriver, the support ring A for the cover glass. d) Replace the lamp with the same type (halogen , max 20 W , 12 Volt , G4 fitting). Round halogen light How to replace the dicroic lamp: a) Check that the equipment is disconnected from the power supply. B) Remove the lamp with the help of a screwdriver (see figure) c) Replace the lamp with a similar one (dichroic, max 20 W, 12 Volt). How to replace a square halogen light: a) Check that the equipment is disconnected from the power supply. B) Open the panel completely till 90° (see figure) pressing the PUSH button c) Replace the lamp with a similar one (halogen, max 20 W, 12 Volt, G4 connection). If the panel does not close correctly repeat the operation at point b. Square halogen light (Section reserved for qualified installers) Replacing the fluorescent tube: a) Disconnect the device from the mains; b) Unscrew the fixing screws and remove the bottom panel; c) Remove the fluorescent tube, by rotating through 90°, and replace it with one of similar features (8W-13W-21W-28W according with the model); d) Reconnect the device to the mains. Special attention should be paid to the metal grease-trapping filters and the charcoal filters. [. . . ] The electrical system features an earth connection in compliance with international safety standards; furthermore, it is compliant with the European standard for electromagnetic compatibility. Make sure the mains voltage corresponds to the values on the rating plate located inside the range hood. The minimum safety distance between the cooktop and the range hood must be at least 65 cm. - Ensure there is adequate ventilation of the room when the rangehood is used at the same time as appliances burning gas or other fuels. [. . . ]