User manual FALMEC LAGUNA INSTALLATION SHEET

[. . . ] Do not allow children or impaired persons to operate the equipment unless they are supervised by a person who shall make sure that the equipment is used safely. the hood is designed exclusively to extract cooking fumes coming from household kitchens. The manufacturer shall not be liable for damage caused by different uses of the hood. [. . . ] Before cleaning or maintenance works make sure that the equipment is disconnected from the power supply line. The manufacturer shall not be liable for any damage caused by a wrong installation or incorrect use of the equipment, in which case the warranty shall be void and no request for damage shall be accepted. The new equipment is covered by warranty in compliance with the current regulations. The warranty terms are indicated either on the last page of the instructions for use or in a warranty document supplied by the distributor together with the equipment. The equipment can be wall mounted, ceiling mounted or floor mounted (horizontally or vertically, see fig. 1) After having decided where and how the equipment is to be installed, secure the brackets (provided) with the screws (provided). 2) Place the equipment exactly where it is going to be installed, mark the location of the holes on the wall. The equipment can be installed onto outside It should be installed in an area that is protected from the rain, snow, wind, etc. , because water and humidity could infiltrate the equipment and damage it. 1) Position the top flange (F) of the equipment exactly where it is going to be fixed and mark the location of the holes (F1. The diameter of the holes must be suitable for the diameter of the screw anchors (see fig. 3) Insert the 60mm plastic pipe (for the power cable with plug and for the wires for connecting the hood's control panel) into the 60mm hole on the wall. 6) Secure the equipment without the steel outer cover (which has been previously removed). Take care to align the holes of the top flange (F) of the equipment with the holes on the wall. [. . . ] 6) Secure the equipment without the steel outer cover (which has been previously removed). Take care to align the holes of the top flange (F) of the equipment with the holes on the wall. 7) Install the steel cover, making sure the grid is aligned with the air outlet of the equipment (see fig. [. . . ]