User manual FALMEC QUASAR

[. . . ] It is dangerous to modify or attempt to modify the characteristics of this system. In the event of malfunctions or if repairs are required to the appliance, do not attempt to solve the problems directly. For all repair and other work on the appliance, contact an authorised service/spare parts centre. Always check that all the electrical parts (lights, exhaust device), are off when the appliance is not being used. [. . . ] The range hood is used at the same time as appliances burning gas or other fuels, according to the standard. Deviation for Germany: When the range hood and appliances supplied with energy other than electricity are simultaneously in operation, the negative pressure in the room must not exceed 4 Pa (4x10 E-5 bar). In this version, the air passes through charcoal filters for purification, and is then recirculated back into the kitchen. Check that the charcoal filters are fitted to the motor, and if not, install them as described in the instructions in point H. if the hood is of filtering type , remove the non-return valve fitted at the motor's outlet. For maximum efficiency, the third speed should be used when there are strong odours or a lot of steam, the second speed in normal conditions, and the first speed for keeping the air clean with minimum energy consumption. The range hood should be switched on when starting to cook, and left on until the odours disappear. OFF: light off; Pushbutton Press to reduce motor speed Speed 1, 2 and 3 are indicated by the number of LEDs that light up (excluding the light and the timer LEDs). Pushbutton + Press to increase motor speed Speed 1, 2 and 3 are indicated by the number of LEDs that light up (excluding the light and the timer LEDs). The function "desired speed" enables to start the motor at the speed that was selected before the hood was last turned off. WARNING: Install the hood away from sources of electromagnetic waves, as these could affect the correct operation of the electronic system. The maximum operating distance could be less than 5 metres in case of electromagnetic interference by other equipment. ­ and + pushbutton: increase/decrease speed (to start the motor press either the + or the ­ pushbutton). Instructions for changing the code (only in case of malfunctions caused by interferences): Disconnect the hood from the power supply Remove the cover of the remote control, change the code with the levers. Connect the hood to the power supply and make sure the lights and the motors are off. When the red LED of the control panel lights up press any of the buttons on the control panel. timer and `filter clogged' alarm pushbutton · This function allows the automatic turning off of the hood after running for 15 minutes at the speed previously set (the pushbutton shows a flickering light). ⷠAfter about 30 hours of running the pushbutton indicates the need for washing the metal filters (the pushbutton shows a solid red light). To disable the alarm press the pushbutton for a few seconds until the red light turns off. Then turn the hood off and on again to check that the alarm has disappeared. [. . . ] The minimum safety distance between the cooktop and the range hood must be at least 65 cm. - Ensure there is adequate ventilation of the room when the rangehood is used at the same time as appliances burning gas or other fuels. - Do not flambe under the rangehood - The exhaust air must not be discharged into a flue which is used for exhausting fumes from appliances burning gas or other fuels. - Ensure that all regulations concerning the discharge of exhaust air have been fulfilled before you use the appliance. [. . . ]