User manual FALMEC VIRGOLA3230


If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual FALMEC VIRGOLA3230. We hope that this FALMEC VIRGOLA3230 user guide will be useful to you.

FALMEC VIRGOLA3230 : Download the complete user guide (2385 Ko)

Manual abstract: user guide FALMEC VIRGOLA3230

Detailed instructions for use are in the User's Guide.

[. . . ] The equipment can be used by children over the age of 8 and by persons with reduced physical, sensory and mental abilities, or with no experience or knowledge, as long as they do so under supervision or after having received relative instructions regarding safe use of the equipment and understanding of the dangers connected to it. Cleaning and maintenance by the user must not be carried out by children without supervision. USE AND CLEANING WARNINGS Before cleaning or carrying out maintenance operations, disconnect the equipment by removing the plug or switching of the main switch. Always check that all electrical parts (lights, extractor fan) are of when the equipment is not being used. [. . . ] You are therefore kindly asked to read the booklet carefully in its entirety before using the or cleaning the equipment. The Manufacturer declines all responsibility for any damage caused directly, or indirectly, to persons, things and pets as a consequence of failing to comply with the safety warnings indicated in this booklet. It is imperative that this instructions booklet is kept together with the equipment for any future consultation. 12 ELECTRICAL CONNECTION (only intended for qualiied personnel) Disconnect the equipment from electrical mains power supply before carrying out any operations on the hood. Ensure that the wires inside the hood are not disconnected or cut: in the event of damage, contact your nearest Servicing Department. Connection must be carried out in compliance with the provisions of law in force. Before connecting the hood to the electrical mains power supply, check that: • voltage supply corresponds with what is reported on the data plate located inside the hood; • the electrical system is compliant and can withstand the load (see the technical speciications located inside the hood); • the power supply plug and cable do not come into contact with temperatures exceeding 70 °C; • the power supply system is efectively and properly connected to earth in compliance with regulations in force; • the socket used to connect the hood is within reach. In case of: • devices itted with cables without a plug: the type of plug to use is a ''standardised'' one. The wires must be connected as follows: yellow-green for earthing, blue for neutral and brown for the phase. € ixed equipment not provided with a power supply cable and plug, or any other device that ensures disconnection from the electrical mains, with an opening gap of the contacts that enables total disconnection in overvoltage category III conditions. Said disconnection devices must be provided in the mains power supply in compliance with installation regulations. The Manufacturer declines all responsibility for failure to comply with the safety regulations. Switch on the hood at least one minute before starting to cook to direct fumes and vapours towards the suction surface. After cooking, leave the hood operating until complete extraction of all vapours and odours. By means of the Timer function, it is possible to set auto switch-of function which will allow the hood to turn of automatically after 15 minutes of operation. 1st speed: maintains the circulation of clean air with low electricity consumption. The active carbon ilters must be replaced every 3-4 months, depending on the use of the hood. ELECTRONIC PUSHBUTTON PANEL Motor ON/OFF Upon start-up, the speed is that stored at the previous operation. The speeds are indicated by the LEDs on the keys: FUMES DISCHARGE EXTERNAL EXHAUST HOOD (SUCTION) Increase speed from 1 to 3 Speed 4 is only active for a few minutes, then speed 3 activates. Speed 1 Speed 2 Reduce speed from 3 to 1 In this version the fumes and vapours are discharged outside through the exhaust pipe. To this end, the hood outlet itting must be connected via a pipe, to an external output. Light on/of Short impulse: turn light on and of Long impulse: change light tone from 2700K to 5600K The outlet pipe must have: • a diameter not less than that of the hood itting. [. . . ] Korrekt bortskafelse af dette produkt medvirker til at spare værdifulde resurser og undgå potentielle negative påvirkninger for folkesundheden og omgivelserne, som omvendt kan forårsages af en ukorrekt bortskafelse af afaldet. kontakt venligst de lokale myndigheder , for at indhente yderligere oplysninger om det nærmeste indsamlingspunkt. Der kan være fastsat bøder for ukorrekt bortskafelse af denne type afald i den nationale lovgivning. Brug ikke for meget vand i nærheden af trykpanelet og lamper for at forhindre fugt i at nå elektronikken. [. . . ]


Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual FALMEC VIRGOLA3230 will begin.


Copyright © 2015 - manualRetriever - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.