User manual FRIGIDAIRE ELECTRIC RANGE WITH ES 1000 SERVICE DATASHEET
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual FRIGIDAIRE ELECTRIC RANGE WITH ES 1000. We hope that this FRIGIDAIRE ELECTRIC RANGE WITH ES 1000 user guide will be useful to you.
Manual abstract: user guide FRIGIDAIRE ELECTRIC RANGE WITH ES 1000SERVICE DATASHEET
Detailed instructions for use are in the User's Guide.
[. . . ] The following are examples, but without limitation, of such practices. Before servicing or moving an appliance remove power cord from electrical outlet, trip circuit breaker to OFF, or remove fuse. GROUNDING: The standard color coding for safety ground wires is GREEN or GREEN WITH YELLOW STRIPES. [. . . ] The adjustments made will not change the self-cleaning temperature.
Electronic Oven Control Fault Code Descriptions
Fault Code F10 Likely failure condition/cause
Runaway temperature. Oven heats when no cook cycle is programmed.
Suggested Corrective Action
If Oven is cold: 1. If fault code is present with cold oven test oven temperature sensor probe circuit resistance. If temperature sensor probe circuit is good but fault code remains when oven is cold replace the EOC. If oven is severely overheating/heating when no cook cycle is programmed test oven temperature sensor probe circuit resistance using the RED scale found in the service tech sheet. Also verify that the temperature sensor probe in properly installed in the oven cavity. If oven continues to heat when the power is reapplied, replace the EOC. NOTE: Severe overheating may require the entire oven to be replaced should damage be extensive. Reset power supply to range - Disconnect power, wait 30 seconds and reapply power. If keyboard ciruits check good replace the EOC.
F11
Shorted keypad or selector switch.
F12 F13 F14
EOC Internal software error or failure. Keyboard tail failure.
Disconnect power, wait 30 seconds and reapply power. Check/reseat ribbon harness connections between keyboard touch panel and EOC. . (F30) Check resistance at room temperature & compare to RTD Sensor resistance chart. (F31) Check resistance at room temperature, if less than 500 ohms, replace RTD Sensor Probe. Check for shorted Sensor Probe harness between EOC & Probe connector. Usually this failure code would only appear if the EOC has been replaced with an incorrect version. [. . . ] If motor runs with test cord check continuity of wire harness to lock motor terminals. If harness is good replace the EOC.
F66 F68 F69 F90 F91 F92 F93 F94 F95
Tech Sheet Abbreviations and Terminology
EOC = Electronic Oven Control RTD = Resistance Temperature Device. (Temp Probe or VSC = Variable Speed Control Temp Sensor) PS = Power Supply board (PS1 , PS2, etc. ) TCO = Thermal Cut Out also "Thermo Disc" or "Thermal Limiter"
Keypad Test Matrix
IMPORTANT
DO NOT REMOVE THIS BAG OR DESTROY THE CONTENTS
WIRING DIAGRAMS AND SERVICE INFORMATION ENCLOSED
REPLACE CONTENTS IN BAG
p/n 316904402en (0905)
Left side
Right side
View: control membrane overlay from front
To test keypad function check for continuity between indicated pin locations while pressing keypad. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE FRIGIDAIRE ELECTRIC RANGE WITH ES 1000
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual FRIGIDAIRE ELECTRIC RANGE WITH ES 1000 will begin.