User manual FUJIFILM FINEPIX F610

[. . . ] Getting Ready Using the Camera Advanced Features Settings Software Installation This manual will show you how to use your FUJIFILM DIGITAL CAMERA FinePix F610 correctly. Please follow the instructions carefully. Viewing Images BL00271-201(1) Warning To prevent fire or shock hazard, do not expose the unit to rain or moisture. EC Declaration of Conformity to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. You are cautioned that any changes or modifications not expressly approved in this manual could void the user's authority to operate the equipment. [. . . ] AUTO: Automatic adjustment (Shooting to show the ambience of the light source) 6 : Shooting outdoors in fine weather 7 : Shooting in shade 9 : Shooting under "Daylight" fluorescent 0 : Shooting under "Warm White" - : Shooting under "Cool White" fluorescent 8 : Shooting in incandescent light lamps fluorescent lamps lamps N Using the 2-second self-timer N This is useful when you have the camera on a tripod and you want to avoid camera shake. 2 1 0 Bebeep 1 Press the Shutter button down halfway to focus on the subject. 2 Without releasing the Shutter button, press the button all the way down (fully pressed) to start the self-timer. !G When the flash fires, the white balance setting for the flash is used. G The color tones may vary somewhat depending on the shooting conditions (light source, etc. ). to Suppressed Flash (P. 45). H FOCUS MODE AF (MULTI) Advanced Features 2 0 Beep The camera automatically recognizes the subject in the central area of the screen and adjusts the focus accordingly. !G Take care not to stand in front of the lens when you press the AF (CENTER) The camera focuses on the center of the screen. shutter button as this can prevent the correct focus or brightness (exposure) being obtained. CONTINUOUS AF The camera focuses continuously on the main subject in the AF frame. Use this mode to photograph moving subjects. 3 The self-timer lamp lights and then starts flashing until the picture is taken. !G To stop the self-timer, once it has started running, press the "BACK" button. AF AREA You can change the position on the screen where the camera focuses. Use this feature when you have composed your shot using a tripod and then want to change the focusing position. I Self-timer Lamp Display * ( Lit for 5 seconds Blinking for 5 seconds Blinking for 2 seconds MF (Manual Focus) 4 A countdown is displayed on the LCD monitor indicating the time remaining until the picture is taken. Self-timer mode is automatically cancelled after each shot. Use manual focus for subjects that are not suitable for Auto Focus or where you want the focus fixed for a shot. When you select area-selection CONTINUOUS AF, AF AREA or MF (manual focus), the LCD monitor cannot be switched off. 50 Continued 51 STILL IMAGE MENU PHOTOGRAPHY MENU AF (MULTI) Pressed halfway If you press the Shutter button down halfway, the camera automatically recognizes any strongly contrasting subject near the center of the screen and displays the AF frame over subject in focus. 1 10 2 0 AF AREA 1 Press the "a", "b", "d" or "c" to move the ":" (target point) to the position on which you want to focus. 2 Press the "MENU/OK" button to confirm the position. Before moving !G If the camera has difficulty in focusing on the main subject, select the "AF (CENTER)" focusing mode and use AF/AE lock (P. 26). After moving AF (CENTER) The camera focuses on the center of the screen. This is a useful feature when used for shots using AF/AE lock (P. 26). 2 The AF frame is displayed in the location to which the target point was moved. To move the AF frame again, perform the procedure again from the menu. CONTINUOUS AF The camera focuses continuously on the main subject in the AF frame. Use this mode to photograph moving subjects. Regardless of the AF frame location, the exposure is always set using the area in the center of the screen. Advanced Features MF (Manual Focus) Page 3/3 is added on the display panel. "R": Focus further away. Because the camera is always adjusting the focus without the Shutter button being pressed, note the following: i The battery level (power consumption increases because data is being overwritten in the camera's internal memory). i If the Power Save feature is set to "OFF", particular attention must be given to the battery level. N Notes on Using Continuous AF N N Mastering Manual Focusing N Use a tripod to prevent the image from becoming unfocused when the camera moves. By pressing the "E" button, you can adjust the focus more quickly using the Auto focus function (One-push AF function). 52 53 STILL IMAGE MENU PHOTOGRAPHY MENU PLAYBACK FUNCTIONS o ERASE FRAME 2 0 1 Set the Power switch to "w". 2 Press "d" or "c" to select the frame (file) to be erased. Mistakenly erased frames (files) cannot be recovered. Copy important frames (files) that should not be erased to a PC's hard disk, etc. P PHOTOMETRY Use this mode for shots where the brightness of the subject and background differ markedly and the light is not metered as desired in MULTI mode. ) MULTI (Pattern): Light metering where the camera automatically assesses the scene and selects the optimum exposure. _ SPOT: Light metering where the exposure is optimized for the center of the image. + AVERAGE: Light metering where an average value for the entire image is used. 1 10 2 Press the "W " button. [. . . ] Do not use chargers other than the specified model to charge the battery. Any of these actions can cause the battery to burst or leak and cause fire or injury as a result. Use only the battery or AC power adapters specified for use with this camera. If the battery leaks and fluid gets into your eyes or comes into contact with your skin or clothing, this can cause injury or loss of eyesight. [. . . ]