User manual FUJIFILM INSTAX SHARE SP-2

[. . . ] 39 After reading this User’s Guide, keep it in a safe, easy to find place where you can refer to it if needed. 29 Parts Name 1 8 EN 2 3 4 5 10 6 7 9 1 2 3 30 4 Print exit POWER button REPRINT button USB connector cover 5 6 7 8 USB connector Film remaining LED Battery remaining LED Back cover lock 9 10 Back cover Battery cover Before Use Before using the printer, install the instax SHARE application on your device. € When you are using an Android OS device, search for “instax SHARE” in the Google Play, then install the application. € When you are using an iOS device, search for “instax SHARE” in the App Store, then install the application. [. . . ] 45 IMPORTANT SAFETY NOTICE This product has been designed with safety in mind, and to provide safe service when handled correctly and in accordance with the User’s Guide and instructions. It is important that both the product and the INSTAX film are handled properly and used only to print pictures as instructed in this User’s Guide and in the INSTAX mini film instructions. For your ease and safety, please follow what is written in this User’s Guide. It is also a good idea to keep this User’s Guide in a safe, easy to find place where you can refer to it if needed. WARNING If the printer (or batteries) becomes hot, emits smoke or a burnt smell or otherwise seems abnormal, immediately remove the batteries. (Take particular care to avoid burns when removing the batteries or pull out the USB cable. Doing so could damage the USB cable and cause a fire or electric shock. Do not cover or wrap the printer or the AC power adapter in a cloth or blanket. This can cause heat to build up and distort the casing or cause a fire. When using the printer, make sure that the battery cover is attached; otherwise, you may be injured. The “CE” mark certifies that this product satisfies the requirements of the EU (European Union) regarding safety, public health, environment and consumer protection. (“CE” is the abbreviation of Conformité Européenne. ) Hereby, FUJIFILM, declares that this printer is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 47 EN Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Note: This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. Note: FCC/INDUSTRY CANADA Radiation Exposure Statement: This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the IC radio frequency (RF) Exposure rules. [. . . ] required Required Risk of explosion if battery is replaced by an incorrect type. Contact with other metallic objects or batteries could cause the battery to ignite or burst. 53 CAUTION Required Required When you are cleaning the printer or you do not plan to use the printer for an extended period, remove the battery. Continued use of the printer when it is emitting smoke, is emitting any unusual odor, or is in any other abnormal state can cause a fire or electric shock. [. . . ]