User manual GAGGENAU AH 360-120

[. . . ] Tips and hints in the chapter entitled "Cleaning and care" will make sure that your appliance will stay operable and beautiful for a long time. Important notes 1. 1 For your safety Damaged appliances must not be operated. Connecting cables must not come into contact with hot cooking surfaces. The user is responsible for expert use and the perfect condition of the appliance. [. . . ] Note: You can change to any ventilation level, and the Coanda level remains set. 8 ­ Press the "Coanda level" key or turn the "Ventilation level" knob to the 0 position. 7 3. 2 Special functions 0 0 1 2 3 Intensive level You should select the intensive level when browning and frying in an open pan. After a few minutes, the appliance switches back automatically to the previously selected ventilation level. The appliance is now operated at the intensive level for a few minutes and then switches off automatically. Ending the intensive level prematurely: ­ Turn the "Ventilation level" knob to the 0 position or ­ turn the "Ventilation level" knob to any level or ­ press the intensive level key once again. Fig. 10 After-running Switching on: ­ Press the (After-running) key. ­ The (After-running) symbol and ventilation level 2 light up on the display (Fig. or ­ Turn the "Ventilation level" control knob to any level. ­ The (After-running) symbol and the set ventilation level light up on the display (Fig. Switching off: ­ Turn the "Ventilation level" control knob to the 0 position. Cleaning the grease filters: The (Grease filter saturation) symbol flashes on the display after an operating time of 30 hours. Flashing of this symbol signals to you that the grease filters have to be cleaned. The grease filters can be cleaned at any time, even if the (Grease filter saturation) symbol does not flash. Proceed as follows: ­ Grip the grease filter handles and press the slide towards the rear. ­ Pull the grease filter out of its mount in the downward direction (Fig. You can clean the metal grease filters in a dishwasher at a maximum temperature of 65 °C. Place the grease filters vertically in the dishwasher to ensure that no food remainders will stay on them. Slight discoloration can occur when cleaning the grease filters in a dishwasher. When replacing the grease filters, wipe out the inner part of the housing with hot detergent solution. Note: The handles of the grease filters must be visible after installation. They can no longer be removed if the handles are in the inner part of the housing. Reinsert the grease filters in the hood after cleaning. Press the (Grease filter) key to set the elapsed hours counter to zero; the (Grease filter) symbol stops flashing. [. . . ] ­ With the aid of the drilling template, mark the positions of the screws on the wall. ­ Pay attention to the minimum clearance of 650 mm for electric cookers and 750 mm for gas cookers. The bottom edge of the template corresponds to the bottom from edge of the hood. ­ Using the drilling template, drill the 6 holes for the hood (area I of the drilling template) and the two holes for suspending the chimney (area II of the drilling template). [. . . ]