User manual GAGGENAU AH 600-190

[. . . ] Operating and assembly instructions AH 600-190 Extractor hood 0 0 1 2 3 AH 600-190 Preface 1. Important notes 1. 1 For your safety 1. 2 Operating for the first time 1. 3 About use 2. Structure and operating principle 2. 1 Structure of the appliance 2. 2 Accessories/special accessories 2. 3 Operating principle 3. Assembly instructions 6. 1 Technical data 6. 2 Installation Page 3-4 Page 3 Page 4 Page 4 Page 5-6 Page 5 Page 5 Page 6 Page 7-8 Page 7 Page 8 Page 9-10 Page 11 Page12-17 Page 12 Page 12-17 1 Preface With your new extractor hood, working in the kitchen will be even more fun. [. . . ] 7 3. 2 Special functions 0 0 1 2 3 Intensive level You should select the intensive level when browning and frying in an open pan. After a few minutes, the appliance switches back automatically to the previously selected ventilation level. The appliance is now operated at the intensive level for a few minutes and then switches off automatically. Ending the intensive level prematurely: ­ Turn the "Ventilation level" knob to the 0 position or ­ turn the "Ventilation level" knob to any level or ­ press the intensive level key once again. Fig. 11 After-running Switching on: ­ Press the (After-running) key. ­ The (After-running) symbol and ventilation level 2 light up on the display (Fig. or ­ Turn the "Ventilation level" control knob to any level. ­ The (After-running) symbol and the set ventilation level light up on the display (Fig. Switching off: ­ Turn the "Ventilation level" control knob to the 0 position. Cleaning and care Cleaning the grease filters: The (Grease filter saturation) symbol flashes on the display after an operating time of 30 hours. Flashing of this symbol signals to you that the grease filters have to be cleaned. The grease filters can be cleaned at any time, even if the (Grease filter saturation) symbol does not flash. Proceed as follows: ­ Grip the grease filter handles and press the slide towards the rear. ­ Pull the grease filter out of its mount in the downward direction (Fig. You can clean the metal grease filters in a dishwasher at a maximum temperature of 65 °C. Place the grease filters vertically in the dishwasher to ensure that no food remainders will stay on them. Slight discoloration can occur when cleaning the grease filters in a dishwasher. Fig. 13 When replacing the grease filters, wipe out the inner part of the housing with hot detergent solution. Install them in the reverse order to removal. Note: The handles of the grease filters must be visible after installation. They can no longer be removed if the handles are in the inner part of the housing. Press the (Grease filter) key to set the elapsed hours counter to zero; the (Grease filter) symbol stops flashing. The lamp cover tilts down and cannot be removed from the appliance (Fig. 15 Defective lamps must only be replaced by lamps of the same type (Cool Beam)! [. . . ] Adjust the suspended element with the recessed head screw and align the hood using a spirit level (Fig. 19 14 ­ Secure the hood to the wall using the 4 screws b with shims c (Fig. 20 ­ Join the chimney shoe with the chimney base using the 6 screws (3. 5 x 9. 5 mm) (Fig. Note: Avoid scratches when fitting the elements into one another by placing the assembly template, for example, over the edge of the bottom chimney paneling to protect it. Fig. [. . . ]