User manual GAGGENAU AH 900-171

[. . . ] Ensure that the protective conductor system of the domestic electricity supply has been installed correctly. Electrical connection conditions must correspond with the specifications on the rating plate of the dishwasher. If the dishwasher is to be installed in a high-sided unit, ensure that the unit is attached properly and also at the rear. Built-under and built-in appliances should always be installed under a continuous work surface which is attached to the adjacent cupboards, in order to ensure that the appliance is entirely stable. [. . . ] Observance of the operating instructions or information on the packaging of the combined detergents determines their effectiveness. Note Even if the rinse aid and/or salt refill indicator is lit, the rinse programme runs correctly when 3in1 products are used. If the rinse aid refill indicator 6 or salt refill 5 indicator is defective and you would like to switch it off, proceed as follows: 11 Overview of programmes The max. The corresponding programmes for your appliance can be found on the fascia. Soups, soufflés, potatoes, pastries, rice, eggs, fried food Mixed Delicate Mixed Soups, potatoes, pastries, rice, eggs, fried food Coffee, cake, milk, sausage, cold drinks, salads Amount of food remnants State of food remnant Wash programme Very adhesive Intensive 70_ Large Medium Auto 55_-65_ Eco 50_ Little Very little Lightly Adhesive Rinse off if the dishes have been stacked for several days in the dishwash er prior to washing. Gentle 40_ Quick 45_ Prerinse The programme sequence is optimised and adjusted according to the degree of soiling on the utensils. Programmesequence Prerinse 40_ Prerinse Clean 50_ Intermediate rinse Clean 65_ Dry Prerinse Clean 40_ Intermediate rinse Clean 55_ Dry Clean 45_ Intermediate rinse Clean 55_ Prerinse Clean 70_ Intermediate rinse Clean 70_ Dry Dry Programme selection The most appropriate programme can be identified by comparing the type of crockery, cutlery, etc. , as well as the amount and condition of food remains, with the details contained in the programme overview. You will find the appropriate programme information in the introduction. 12 Washing dishes Reduce costs! If only a small number of dishes have been loaded into the dishwasher, selecting a programme that operates at the next lowest temperature will usually suffice. Remaining running time display When the appliance has started, the expected programme running time is displayed. The programmed running time is affected by the water temperature, the number of dishes, as well as the degree of soiling. If these conditions are changed, the running time (depending on the selected programme) can vary greatly. As the effect is not detected until a programme is running, the time may be longer or shorter than expected. Programme data The programme specifications can be found in the summary of instructions. Greater deviations may occur due to: different amounts of dishes temperature of mains water supply pressure of mains water supply ambient temperature fluctuations in mains voltage machine-related factors (e. g. Energy and water consumption is reduced by up to 1/4 when dishes are washed in the upper basket only. Water consumption values are based on a water hardness setting of 4. Time delay * * on applicable models You can delay the start of the programme in 1-hour steps up to 19 hours. The time reduction affects the following programmes: Intensive: Time reduction up to 25 % Auto: Time reduction up to 25 % Eco: Time reduction up to 58 % Terminating the programme (Reset) Simultaneously press programme buttons A and C for approx. Switch off the main switch 1 . Top basket washing only * If there are only a few utensils (e. g. Use slightly less detergent than is recommended for a complete load. Changing the programme When the appliance is switched on, the programme can be changed within minutes. The new remaining time consists of the remaining time of the previous programme section and the remaining time of the newly selected programme. Bottom basket washing only * If there are only a few utensils (e. g. Use slightly less detergent than is recommended for a complete load. Intensive drying In the final rinse the appliance operates at a higher temperature and therefore an improved drying result is obtained. (Caution if utensils are fragile!) Hold down programme button A and press main switch until 1 the digital display illuminates. The LED for button A flashes and the digital display 9 displays the factory setting (off) or (on). Switch off the main switch 1 . 14 Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents problems. Overall condition of the machine Check washing chamber for grease and limescale deposits. If you find such deposits: Fill the detergent dispenser with detergent, start the appliance without utensils in the programme which has the highest wash temperature. Clean the appliance with detergents/ appliance cleaners which are particularly suitable for use with dishwashers. [. . . ] To prevent children from locking themselves in the appliance and suffocating, destroy the door lock and childproof lock (if fitted). Please contribute to a better environment by disposing of packaging materials in an environmentally-friendly manner. All plastic parts of the appliance are identified by internationally standardised symbols (e. g. When the appliance is being disposed of, the plastic waste can be sorted for environmentally-friendly recycling. [. . . ]