User manual GAGGENAU AH532190

[. . . ] Tips and hints in the chapter entitled "Cleaning and care" will make sure that your appliance will stay operable and beautiful for a long time. Important notes 1. 1 For your safety ­ Damaged appliances must not be operated. ­ The appliance must only be connected by an authorised specialist, paying attention to the relevant regulations of the power supply companies and the regional construction regulations. ­ Connecting cables must not come into contact with hot cooking surfaces. [. . . ] 5 6 The Int key for the intensive level should be pressed when browning and frying in an open pan (see Fig. If you have switched on the hood by selecting the intensive level, it will be switched off again automatically after 5 minutes. Fig. 6 If you press the Int key while the hood is running at fan level 1, 2 or 3, the electronic control will switch back automatically to the previously selected fan level after 5 minutes (see Fig. 7 If you would like to end the intensive level before the five minutes have elapsed, press the 0 key ("Motor off") or select a different level (see Fig. It is possible to switch off the extraction function at any time by pressing the 0 key (motor "off"). Fig. 8 7 Special functions: Intensive time: You can set the intensive level running time to 3, 5 or 10 minutes by simultaneously pressing the Int key and the 1, 2 or 3 key and you can store this setting (see Fig. First press the required key 1, 2, 3 or Int and then press the key (see Fig. After these ten minutes, the ventilation switches off, but the lighting stays on. or or or Fig. 11 or or Interval ventilation: Interval ventilation is a special feature of this appliance which periodically activates the fan for five minutes every hour. You can activate this function by simultaneously pressing the 0 key and, depending on the required extraction capacity, the 1, 2 or 3 key (see Fig. This mode of operation is indicated by alternating illumination of the key together with the corresponding fan level indicator. You can switch off interval ventilation by pressing the 0 key (see Fig. Cleaning and care Cleaning the grease filters The grease filter saturation display F flashes after an operating time of 30 hours to you indicate to you that you should clean the grease filter (see Fig. The grease filters can of course be cleaned at any time, even if the grease filter saturation display has not started to flash. The stainless steel grease filters can be removed easily for cleaning (see Fig. Then pull the grease filter downwards out of the holder; repeat the operation for the other grease filters. You can clean the stainless steel grease filters in a dishwasher at a maximum temperature of 65°C, where it should be supported vertically to allow food or rinsing residues to drain off. If possible, the inner parts of the housing should be wiped out in hot rinsing water when replacing the filters. Caution: when cleaning the inside of the housing, beware of protruding parts. Fig. 13 After having cleaned them, re-insert the grease filters in the wall extractor in reverse order. Important: the handles of both grease filters must be visible after assembly. Fig. Flashing of the indicating lamp goes off. 9 Cleaning the extractor hood Clean the extractor hood and the aluminiumdesign ventilation ducts (LK 530-011/021) with a soft cloth and mild detergent solution only. [. . . ] In the top two securing holes for the hood, fix the two hooks d with the countersunk screws c. Note: pay attention to any special accessories that you may have to fit. Adjust the suspended element with the recessed head screw and align the hood using a spirit level (Fig. 20 15 ­ Secure the hood on the wall with the four screws b (Fig. [. . . ]